Scribd
Upload
27 views

Usman Institute of Technology: Industrial Electronics (Ee-421)

This document outlines an experiment on using Siemens PLC software. The objectives are to understand operation of ladder program simulation, hardware configuration, and combinational and sequential logic circuits. The experiment involves creating combinational logic circuits to control LEDs with switches using ladder logic. It also tasks implementing logical operations like AND, OR, NAND, NOR, XOR, XNOR and NOT in ladder logic using SIMATIC Manager STEP7 software.

Uploaded by

Tausique Sheikh
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
27 views

Usman Institute of Technology: Industrial Electronics (Ee-421)

This document outlines an experiment on using Siemens PLC software. The objectives are to understand operation of ladder program simulation, hardware configuration, and combinational and sequential logic circuits. The experiment involves creating combinational logic circuits to control LEDs with switches using ladder logic. It also tasks implementing logical operations like AND, OR, NAND, NOR, XOR, XNOR and NOT in ladder logic using SIMATIC Manager STEP7 software.

Uploaded by

Tausique Sheikh
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 22

USMAN INSTITUTE OF TECHNOLOGY

DEPARTMENT OF ELECTRICAL ENGINEERING

INDUSTRIAL ELECTRONICS (EE-421)


SPRING-2016

Engr. Kashif Ali Arshad


Engr. Mehr Un Nisa

EXPERIMENT # 7: INTRODUCTION TO SIEMENS PLC SOFTWARE

Name of Student:

Roll No.: Group:

Date of Experiment :

Report Submitted on : _

Marks Obtained :

Remarks if any :

Signature :
OBJECTIVE

1. To understand the Operation for Ladder Program Simulation using SIMATIC S7


Software.
2. To understand the Hardware Configuration using SIMATIC S7 Software.
3. To create understanding of combinational logic & sequential logic circuits.

INTRODUCTION TO STEP 7 SIMATIC MANAGER


Task # 1

To create understanding of combinational logic circuits on ladder logic.


To control LED with switch
1. Press ON
2. Press OFF
3. Latch Set / Reset

EQUIPMENT REQUIRED
PC, SIMATIC S-7 Editing software, PLC trainer, Programming cables.
PROCEDURE
Repeat the same procedure as given and implement the Combinational logics.

TASK # 2
To implement logical operations: AND, OR, NAND, NOR, XOR, XNOR & NOT using Ladder
logic in SIMATIC Manager STEP7.

PROCEDURE
Write the truth table of each logical operation and implement their respective ladder logic in
SIMATIC Manager STEP7.

You might also like