0% found this document useful (0 votes)
38 views1 page

Stall Speed: Main Menu

This document provides instructions for testing an engine's stall speed while warning that the test should not exceed 10 seconds to prevent transmission damage. It advises engaging the parking brake, connecting a tachometer, shifting to different gears, and fully depressing the brake and accelerator for 6-8 seconds in each gear to note the engine speed. Stall speed should be around 2350 RPM and within the range of 2200-2500 RPM.

Uploaded by

softall
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
38 views1 page

Stall Speed: Main Menu

This document provides instructions for testing an engine's stall speed while warning that the test should not exceed 10 seconds to prevent transmission damage. It advises engaging the parking brake, connecting a tachometer, shifting to different gears, and fully depressing the brake and accelerator for 6-8 seconds in each gear to note the engine speed. Stall speed should be around 2350 RPM and within the range of 2200-2500 RPM.

Uploaded by

softall
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Main Menu Table of Contents

Stall Speed
Test
CAUTION:
To prevent transmission damage, do not test stall speed for more than 10 seconds at a time.
Do not shift the lever while raising the engine speed.
Be sure to remove the pressure gauge before testing stall speed.

1. Engage the parking brake and block the front wheels.

2. Connect a tachometer to the engine, and start the engine.

3. Make sure the A/C switch is OFF.

4. After the engine has warmed up to normal operating temperature (the radiator fan comes on), shift into position.

5. Fully depress the brake pedal and accelerator for 6 to 8 seconds, and note engine speed.

6. Allow two minutes for cooling, then repeat the test in and positions.

NOTE:
Stall speed tests should be used for diagnostic purposes only.
Stall speed should be the same in and _ positions.

Stall Speed RPM:


Specification: 2,350 rpm
Service Limit: 2,200 - 2,500 rpm

You might also like