Scribd
Upload
22 views

Steel Specification

The document outlines steel material specifications, requiring rolled shapes, channels, and angels to conform to minimum grade S275JR; hollow structural sections to minimum grade S235JR; and hot rolled plates to minimum grade S235JR. Bolts must be a minimum grade 8.8. Welding is to be 5mm fillet welds as specified, with splices only at locations indicated on structural drawings unless approved otherwise. Shop drawings must show modifications for erection or other trades for approval. Field modifications require prior approval, and contractors must submit an erection procedure for review. Steel elements will be designed for final, not construction, loads.

Uploaded by

HaymanAHMED
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
22 views

Steel Specification

The document outlines steel material specifications, requiring rolled shapes, channels, and angels to conform to minimum grade S275JR; hollow structural sections to minimum grade S235JR; and hot rolled plates to minimum grade S235JR. Bolts must be a minimum grade 8.8. Welding is to be 5mm fillet welds as specified, with splices only at locations indicated on structural drawings unless approved otherwise. Shop drawings must show modifications for erection or other trades for approval. Field modifications require prior approval, and contractors must submit an erection procedure for review. Steel elements will be designed for final, not construction, loads.

Uploaded by

HaymanAHMED
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Structural steel specs:

Steel materials shall conform to the following minimum requirements unless otherwise noted on
the contract documents:

Rolled shapes, channels and angels: according to EN 10025 with minimum grade S275JR.
Hollow structural sections (circular or rectangular or square sections): cold formed sections
according to EN 10210 with minimum grade S235JR.
Hot rolled plates (for flanges and base plates): according to EN 10025 with minimum grade
S235JR.
Bolts and Anchor bolts: full threated bolts with minimum grade 8.8 according to ISO 898-1.
all welding should be on shop fillet welding with size 5 mm unless if not mentioned using welding
wire according to ER 70 S - 6
splices shall be allowed only at locations specifically indicated on the Structural drawings unless
approved otherwise by the per in writing.
show all copes, holes, openings and modifications required in structural Steel members for
erection or the work of other trades on the shop drawings for approval by the architect and
structural engineer.
field modification of structural steel is prohibited without prior Approval of the architect and
structural engineer.
the contractor shall submit a steel erection procedure, prepared under The supervision of a
structural engineer (the contractor's engineer) for Review by the structural engineer of record.
This procedure must include the Proposed survey required by the steel specifications.
The steel elements calculated only on the final stand so if the structure during construction
behave in different case so the contractor should design the structure according to the loads
during construction.

You might also like