Scribd
Upload
1K views

How To - Setup Serial Console Connection Using PuTTy PDF

To set up a serial console connection between a Cyberoam appliance and a PC using PuTTy, follow these steps: 1. Connect one end of the supplied serial cable to the console port on the Cyberoam and the other to the PC serial port. 2. Launch PuTTy and select Serial connection type. Configure COM1 port, 9600 baud rate, 8 data bits, 1 stop bit, no parity, no flow control. 3. Click Open in PuTTy to establish the connection and see the Cyberoam CLI login page. 4. Access the CLI using the administrator password.

Uploaded by

olfa0
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
1K views

How To - Setup Serial Console Connection Using PuTTy PDF

To set up a serial console connection between a Cyberoam appliance and a PC using PuTTy, follow these steps: 1. Connect one end of the supplied serial cable to the console port on the Cyberoam and the other to the PC serial port. 2. Launch PuTTy and select Serial connection type. Configure COM1 port, 9600 baud rate, 8 data bits, 1 stop bit, no parity, no flow control. 3. Click Open in PuTTy to establish the connection and see the Cyberoam CLI login page. 4. Access the CLI using the administrator password.

Uploaded by

olfa0
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

How To - Setup

HowSerial
To SetupConsole
Serial Console Connection using
Connection Using Putty
PuTTy
Applicable Version: 10.00 onwards
A serial connection can be established between any Cyberoam Appliance and a PC using a
console/serial cable (cable having a 9 pin DB supplied with the Cyberoam appliance). PuTTy, an
open source SSH and Telnet client, can be used to setup the serial connection. To download PuTTy,
click here.

To setup a serial console connection between Cyberoam Appliance and a PC, follow the steps given
below:

1. Connect one end of the serial cable - RJ45 connector (console cable supplied with Cyberoam
Appliance) to Console port on the front panel of Cyberoam and the other end to the PCs serial
port.

2. Launch PuTTy. Select Connection type as Serial.


How To Setup Serial Console Connection Using Putty

3. Go to Connection > Serial to configure the Options controlling local serial lines according to
table given below:

Parameter Value
Serial line to connect to COM1
Speed (Baud) 9600
Data bits 8
Stop bits 1
Parity None
Flow control None

4. Click Open to establish the connection. Cyberoam CLI login page is displayed.

5. Access Cyberoam CLI using administrator password.


How To Setup Serial Console Connection Using Putty

Note:

If you want to log your PuTTy session or save the entire command line to a local file:
Select Logging under Category > Session.
Select All Session Output and click Browse to select the location to save the log file.

Now, the session outputs will be logged at the specified location as shown in the image.
How To Setup Serial Console Connection Using Putty

Document Version: 1.3 24 June, 2015

You might also like