Scribd
Upload
286 views

Padeye Design Calculation Spreader Bar Lug (Bottom)

The document provides design calculations for a spreader bar lug used to lift loads. It specifies a design load of 12.63 kN based on a working load limit of 1.29 MT and a dynamic amplification factor of 2. It then lists geometric data for the lug components like dimensions, radii, and thicknesses. Finally, it selects a sling with a minimum breaking load of 161.41 kN to meet the factor of safety requirement of 4 given the minimum breaking load needed of 50.52 kN.

Uploaded by

Nasrul Adli
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
286 views

Padeye Design Calculation Spreader Bar Lug (Bottom)

The document provides design calculations for a spreader bar lug used to lift loads. It specifies a design load of 12.63 kN based on a working load limit of 1.29 MT and a dynamic amplification factor of 2. It then lists geometric data for the lug components like dimensions, radii, and thicknesses. Finally, it selects a sling with a minimum breaking load of 161.41 kN to meet the factor of safety requirement of 4 given the minimum breaking load needed of 50.52 kN.

Uploaded by

Nasrul Adli
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

PADEYE DESIGN CALCULATION

SPREADER BAR LUG ( BOTTOM)


Hm

Shackle
Dp pin
P
Main plate

Rm

Ro
Hh

Rc
Cheek plate

Tt

Design Load
No of lug N = 2
Static Lift Load (Working Load Limit), WLL ( STAAD OUTPUT) = 1.29 MT
Dynamic Ampl Factor DAF = 2.00
MT
Dynamic lift load P = ( WLL x DAF ) / N = 12.63 kN 1

Geometric Input Data


Main pl width Hm = 200 mm
Main pl height to centre of pin Hh = 100 mm
Main pl thk Tm = 19 mm
Main pl radius Rm = 57 mm
Cheek pl thk Tc = 10 mm
Cheek pl radius Rc = 52.5 mm
Pin diameter Dp (ref catalog) = 31.8 mm
Pin hole radius Ro1= (Dp+3)/2 = 17.4 mm
Ro2= (1.05*Dp)/2 = 16.7 mm
Max pin hole radius Ro3= (Dp+6)/2 = 18.0 mm
Provide Ro = 25 mm OK!
Weld size (Cheek pl to Main pl) s = 5 mm
Pinhole centre to Ring pl centre
Eccentricity e = 0 mm
Stiffener plate thickness Tr = 0 mm
Support beam flange thickness Tt = 0 mm

Sling selection
Factor of Safety (FOS) = 4
Minimum Breaking Load (MBL) = 50.52 kN
Sling MBL = 161.41 kN OK!
UC = 0.30

Sling MBL = 161.41 kN


Sling Type: 6x19 (9/9/1) / IWRC 16.5 MT
Sling Diameter = 16 mm

You might also like