Scribd
Upload
175 views

Experiment 4

This document provides instructions for Experiment 4 on transmission line demonstration. It includes pre-lab questions to answer and the main steps of the experiment. The key steps are to demonstrate step pulses and sine waves propagating on the transmission line demonstrator, observe the effects of changing attenuation and frequency, study dispersion with step inputs, and observe standing wave patterns for different terminations and frequencies. Snapshots of the wave signals are to be taken as experimental data for the lab report.

Uploaded by

DivpreetSingh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
175 views

Experiment 4

This document provides instructions for Experiment 4 on transmission line demonstration. It includes pre-lab questions to answer and the main steps of the experiment. The key steps are to demonstrate step pulses and sine waves propagating on the transmission line demonstrator, observe the effects of changing attenuation and frequency, study dispersion with step inputs, and observe standing wave patterns for different terminations and frequencies. Snapshots of the wave signals are to be taken as experimental data for the lab report.

Uploaded by

DivpreetSingh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Experiment 4 Transmission Line Demonstrator

This document contains the pre-lab questions that you need to answer in a sheet (1 per group) before you start
the experiment. It also contains the main steps in the experiment, or more importantly, the data that you need
to take for your lab report. Details of how to take that data can be found in the lab manual (attached) with
respect to this experiment.

Pre-Lab questions:
(Answer each question in 2-3 sentences)
i. What is the use of Transmission Line Demonstrator (TLD 511)?
ii. What is the difference between Attenuation and Dispersion of a signal?
iii. What is the difference between a travelling wave and a standing wave? How are standing waves
produced?

Main steps in the experiment:

i. Various kinds of propagating pulses need to be demonstrated. First, using TLD 511, demonstrate
step pulse of given width propagating forward as well as backward.
ii. Then propagate a sine wave on TLD 511, at different frequencies and measure the wavelength
using the Hold button.
iii. With the previously obtained sine wave, gradually increase the attenuation control and observe
the changes. Also, study the effect of change in frequency on this attenuation.
iv. To study dispersion, change the wave to step input, and set some mid-range attenuation. Observe
the changes as compared to previous case. Similarly observe backward attenuation, by reversing
the roles of both ends.
v. Observe the wave signals (step input) for three terminations: Matched load, open circuit and
short circuit cases. Comment upon your expectations versus results obtained.
vi. Observe the phenomenon of Superposition by sending step input pulses from both sides, as well
as by superposing the incident and reflected waves on each other.
vii. Observe the standing wave pattern for different frequencies, for both open circuit and short
circuit terminations. Comment upon the position of nodes and anti-nodes.
viii. Terminate the line with a mismatched load, and notice the partial reflection of incident wave and
formation of standing waves. Experimentally, prove that the standing wave is the sum of incident
and reflected wave.
ix. You are required to take snapshots of the wave from the transmission line demonstrator as
experimental data and show them in the report.

You might also like