Scribd
Upload
853 views

Toolbox Talk 4 Manual Handling

Manual handling injuries are a significant cause of injuries in the construction sector. The talk outlines the need to eliminate manual handling where possible, and if it cannot be eliminated to properly assess loads and use correct lifting techniques. Proper planning of deliveries and storage is important. When lifting, stand close to the load with feet hip-width apart, bend knees and lift with legs while keeping back straight. Always try to avoid twisting or jerky movements when lifting. Site-specific PPE and training requirements should also be reviewed. The main point is to not lift excessive loads.

Uploaded by

Sajid Hussain
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
853 views

Toolbox Talk 4 Manual Handling

Manual handling injuries are a significant cause of injuries in the construction sector. The talk outlines the need to eliminate manual handling where possible, and if it cannot be eliminated to properly assess loads and use correct lifting techniques. Proper planning of deliveries and storage is important. When lifting, stand close to the load with feet hip-width apart, bend knees and lift with legs while keeping back straight. Always try to avoid twisting or jerky movements when lifting. Site-specific PPE and training requirements should also be reviewed. The main point is to not lift excessive loads.

Uploaded by

Sajid Hussain
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Talk No.

4 Manual Handling
Reason for Talk
Manual handlings activated are a significant of injuries in the construction sector.

Main Points
General
You must take reasonable care of your own safety and the safety of others
The primary aim is to eliminate manual handling so far as is reasonably practicable
(i.e. use mechanical handling).
Where manual handling must be carried out then it must be assessed, and proper
procedures must be used.
Plan deliveries and storage to take into account load sizes, locations and distribution.
Assess all loads: are they heavy, bulky, unstable, difficult to grasp, sharp etc? Size up
the load and, if necessary, make a trial lift by rocking it from side to side and then lifting
it a few inches.
Can you handle the load yourself or do you need assistance?
Wear suitable clothing and PPE such as gloves and safety boots to protect against
cuts, crushed toes etc.
Is there sufficient space, suitable lighting and a clear route to where you are taking the
load?
Do not carry a load that will obscure your vision.
If necessary move loads in stages.

Always use a good handling technique:


1. Stand reasonably close to the load, feet hip width apart with one foot slightly forward
pointing in the direction youre going.
2. Bend your knees whilst keeping your back straight and get a secure grip on the load.
4. Breathe in before commencing the lift.
5. Carry out the lift smoothly using the legs to take the strain, keeping the back straight,
chin up, and arms close to the body.
6. Step off in the direction the advanced foot is pointing, keeping the load close to the
body.
7. If necessary, stop for rests en-route and avoid any jerky or twisting movements.

On Site Safety
The presenter should outline / reiterate the site specific requirements of this particular site with
regard to;
PPE
Training & Supervision

Questions
Presenter should request any questions from the audience

MAIN POINT FROM THIS SESSION

DO NOT LIFT EXCESSIVE LOADS

For more toolbox talks visit www.toolboxtalks.ie


Talk No. 4 Manual Handling

Site:

Date: Duration: ________ Hours _______ Minutes

Presented by: Manager:

A safety talk was held at the above site on the following subjects

The undersigned attended the safety talk on the above date.

Name (BLOCK CAPTALS) Signature

Comments:

For more toolbox talks visit www.toolboxtalks.ie

You might also like