Multiple Choice Question Answers
Multiple Choice Question Answers
9. Which type of welded joint is used in the longitudinal joint of a cylindrical pressure vessel
(i) Butt joint
(ii) Lap joint
(iii) Screwed joint
(iv) None
Ans: (i)
10. Which type of welded joint is used in the circumferential joint of a cylindrical pressure vessel
(i) Butt joint
(ii) Lap joint
(iii) Screwed joint
(iv) None
Ans: (ii)
15. Which joint does not fall under lap joint category
(i) Transverse fillet
(ii)Parallel fillet
(iii)Circular fillet
(iv) None
Ans: (iv)
16. Which joint does not fall under the category of a butt joint
(i) Single V
(ii) Double V
(iii) Single U
(iv) None
Ans: (iv)
27. Why are butt welded joints used in longitudinal joints because of ?
(i) High strength requirements
(ii) Low strength requirements
(iii) Low as well as high strength requirements
(iv) None
Ans: (i)
28. Why are lap welded joints used in circumferential joints because of ?
(i) High strength requirements
(ii) Low strength requirements
(iii) Low as well as high strength requirements
(iv) None
Ans: (ii)
31. A single full fillet welded joint can be used for a thickness not greater than
(i) 1/8
(ii) 2/8
(iii) 3/8
(iv) None
Ans: (iii)
32. A double full fillet welded joint can be used for a thickness not greater than
(i) 1/8
(ii) 3/8
(iii) 5/8
(iv) None
Ans: (iii)