Scribd
Upload
16 views

Design A BJT Circuit Network Configuration Based From A Specified AC Parameters

The document outlines three BJT circuit design problems from a course on small signal analysis. The first problem asks students to design a collector feedback configuration with a voltage gain of -160 and current gain of 19. The second problem asks for an emitter-biased CE configuration with a voltage gain of -10 and emitter resistance of 3.8 ohms. The third problem asks for a voltage divider configuration with a voltage gain of -3.24, input impedance of 8.47k ohms, and emitter resistance of 19.64 ohms. Students are instructed to design the circuits based on specified AC parameters and assumptions given for each problem.

Uploaded by

djun033
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
16 views

Design A BJT Circuit Network Configuration Based From A Specified AC Parameters

The document outlines three BJT circuit design problems from a course on small signal analysis. The first problem asks students to design a collector feedback configuration with a voltage gain of -160 and current gain of 19. The second problem asks for an emitter-biased CE configuration with a voltage gain of -10 and emitter resistance of 3.8 ohms. The third problem asks for a voltage divider configuration with a voltage gain of -3.24, input impedance of 8.47k ohms, and emitter resistance of 19.64 ohms. Students are instructed to design the circuits based on specified AC parameters and assumptions given for each problem.

Uploaded by

djun033
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

ECE 402

Topic: BJT Small Signal Analysis


Objective: Design a BJT circuit network configuration based from a specified AC parameters.

1. Design the Collector Feedback Configuration such that it will have a voltage gain Av = -160 and current gain Ai = 19.

Solution:

Designed Circuit:

Seat No: Date:


Name: Section:
ECE 402

Topic: BJT Small Signal Analysis


Objective: Design a BJT circuit network configuration based from a specified AC parameters.

2. Design the CE Emitter-Bias Configuration such that it will have a voltage gain = 10 and = 3.8. Assume that
=

Solution:

Designed Circuit:

Seat No: Date:


Name: Section:
ECE 402

Topic: BJT Small Signal Analysis


Objective: Design a BJT circuit network configuration based from a specified AC parameters.

3. Design the Voltage Divider Configuration such that it will have a voltage gain = 3.24, input impedance =
. and = 19.64. Assume that =

Solution

Designed Circuit:

Seat No: Date:


Name: Section:

You might also like