Scribd
Upload
134 views1 page

Ok 78.16

OK 78.16 is an electrode for welding 0.25C-1Cr-0.3Mo alloyed quenched and tempered steel grades. The weld metal produced has the same heat treatment requirements as the parent plate and is suitable for flame hardening. Welding high tensile strength steel requires preheating to a minimum of 200°C. Typical weld metal composition includes 0.1% C, 0.4% Si, 0.8% Mn, 1.0% Cr, and 0.2% Mo, with a yield stress of 870 MPa, tensile strength of 900 MPa, and 18% elongation.

Uploaded by

Mario Intik
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
134 views1 page

Ok 78.16

OK 78.16 is an electrode for welding 0.25C-1Cr-0.3Mo alloyed quenched and tempered steel grades. The weld metal produced has the same heat treatment requirements as the parent plate and is suitable for flame hardening. Welding high tensile strength steel requires preheating to a minimum of 200°C. Typical weld metal composition includes 0.1% C, 0.4% Si, 0.8% Mn, 1.0% Cr, and 0.2% Mo, with a yield stress of 870 MPa, tensile strength of 900 MPa, and 18% elongation.

Uploaded by

Mario Intik
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

OK 78.

16 SMAW
Type Basic E9018-G

Description Classications
OK 78.16 is a CrMo-alloyed electrode for the wel- SFA/AWS A5.5 E9018-G
ding of 0.25C-1Cr-0.3Mo-alloyed quenched and
tempered steel grades. The heat treatment requi-
rements for the weld metal are the same as
those for the parent plate. The weld metal of OK
78.16 is also suitable for ame hardening. The
welding of high tensile strength steel with OK
78.16 should be carried out at a preheating tem- Typical all weld metal composition, %
perature of minimum 200C.
C Si Mn Cr Mo
Recovery
0.1 0.4 0.8 1.0 0.2
120%

Welding current Typical mech. properties all weld metal


DC(+) Yield stress, MPa 870
Tensile strength, MPa 900

12346 Elongation, %
Charpy V
18

Test temps, C Impact values, J


+20 50

Approvals
DB 10.039.16
UDT DIN 8555
10.039/1

Welding parameters

N. B. H. T.
Kg weld No. of elec- Kg weld Burn-off
Diameter, Length, Welding Arc voltage, metal/kg trodes/kg metal/hour time, s/
mm mm current, A V electrodes weld metal arc time electrode
1.6 300 50-65
2.5 350 75-100 20 0.64 70.0 0.9 58
3.2 450 105-140 21 0.64 32.5 1.4 78
4.0 450 145-195 22 0.66 22.5 1.9 83
5.0 450 190-260 23 0.68 15.0 2.8 86
6.0 450 240-330 25 0.70 10.0 3.6 98

108

You might also like