Scribd
Upload
42 views

Chapter-10 Electrostatic Precipitator: 10.1 Design Data

The document discusses the standard technical features of an electrostatic precipitator (ESP) system for 660/800 MW thermal power units. The ESP for each unit will have 4-6 independently operating gas streams, with each stream in twin compartments. The ESP is designed to meet guarantee and design point requirements for factors like unit loading, coal type, ambient conditions, gas flow, temperature, dust burden, and allowable number of electrical fields and outlet dust levels.

Uploaded by

Dhiraj Satyam
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
42 views

Chapter-10 Electrostatic Precipitator: 10.1 Design Data

The document discusses the standard technical features of an electrostatic precipitator (ESP) system for 660/800 MW thermal power units. The ESP for each unit will have 4-6 independently operating gas streams, with each stream in twin compartments. The ESP is designed to meet guarantee and design point requirements for factors like unit loading, coal type, ambient conditions, gas flow, temperature, dust burden, and allowable number of electrical fields and outlet dust levels.

Uploaded by

Dhiraj Satyam
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Standard Technical Features of BTG System for Supercritical 660/800 MW Thermal Units

CHAPTER- 10

ELECTROSTATIC PRECIPITATOR

10.1 Design Data

The electrostatic precipitator(s) (ESP) of each unit shall be arranged in


minimum four (4) independently operating gas streams (casings) for 660 MW
unit and six (6) independently operating gas streams (casings) for 800 MW
unit. Each gas stream/ casing shall be provided in twin compartments. ESP
shall be designed to comply with the requirements stipulated under guarantee
point and design point in the table below:

Sl. Item Guarantee point Design point


No.
i) Unit loading 100% TMCR 100% BMCR
ii) Type of coal Design coal Worst coal (maximum
ash coal from range)
iii) Ambient air condition 270C temp. and 60% 450C temp. and 60%
RH RH
iv) Gas flow per steam To be worked out To be worked out
generator at the ESP when firing the when firing the
inlet when firing specified design coal specified worst coal
respective coal (m3/sec) at TMCR. with max. ash at
BMCR load,
considering 25%
excess air at
economiser outlet,
15% air heater in
leakage and 2% duct.
v) Gas temperature at ESP 1250C or as predicted 1400C or as predicted
inlet (0C) under conditions under conditions
stipulated above, stipulated above,
whichever is higher. whichever is higher.
vi) Inlet dust burden To be worked out To be worked out
(gm/Nm3) based on 85% of ash based on 85% of ash
or actual predicted or actual predicted
whichever is higher whichever is higher
being carried forward being carried forward
to ESP while firing to ESP while firing
specified design coal. specified worst
(maximum ash) coal.
vii) No. of electrical fields One each in all the One each in all the
out of operation passes passes
viii) Outlet dust burden 50 mg/Nm3 80 mg/Nm3
(mm/Nm3) (maximum) or as per (maximum) or as per
MOEFs requirement MOEFs requirement
whichever is more whichever is more
79

You might also like