Scribd
Upload
451 views2 pages

Obdlink Sx-Quickstart PDF

This document provides instructions for installing and using OBDwiz software and an OBDLink SX scan tool to connect to a vehicle's onboard diagnostic port: 1. Install the necessary USB drivers by inserting the included software CD. 2. Connect the scan tool to the computer's USB port and then to the vehicle's OBDII diagnostic port, typically located under the dashboard. 3. Launch the OBDwiz software to communicate with the vehicle's computer systems.

Uploaded by

Renato Abalos
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
451 views2 pages

Obdlink Sx-Quickstart PDF

This document provides instructions for installing and using OBDwiz software and an OBDLink SX scan tool to connect to a vehicle's onboard diagnostic port: 1. Install the necessary USB drivers by inserting the included software CD. 2. Connect the scan tool to the computer's USB port and then to the vehicle's OBDII diagnostic port, typically located under the dashboard. 3. Launch the OBDwiz software to communicate with the vehicle's computer systems.

Uploaded by

Renato Abalos
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

OBD Quick Start

TM

1. Install drivers 2. Connect scan tool to the PC 5. Install OBDwiz software


Insert the software CD in your CD-ROM drive. If the drivers were successfully installed, the Click on OBDwiz, and follow the prompts to
The scan tool selection menu will automatically status light should turn yellow when you connect install the software:
appear. Click on OBDLink SX: OBDLink SX to your PCs USB port (step A). Red
status light indicates that USB drivers were not
installed properly.

6. Launch OBDwiz software


To launch the software, click on Startg
ProgramsgOBDwizgOBDwiz. The license key
3. Locate the diagnostic connector can be found on the CD case. Click the Auto
If the menu does not appear, click StartgRun, Detect button, then click the Connect button.
type D:\setup.exe (where D is the drive letter of The 16-pin D-shaped diagnostic link connector
your CD-ROM drive), and click OK. (DLC) should be located in the passenger or Technical support
driver's compartment in the area bounded by the
The software selection menu will appear. Click on driver's end of the instrument panel to 300 mm Should you run into problems, technical support
the driver link for your operating system and (~1 ft) beyond the vehicle centerline, attached to is just a click away:
install the drivers: the instrument panel and easy to access from the
driver's seat. The preferred location is between Knowledgebase - contains answers to
the steering column and the vehicle centerline. the most commonly asked questions,
general information about OBD-II, and
troubleshooting information.
4. Connect scan tool to the DLC Forum - allows you to share information
and get support from other OBDLink SX
Turn the vehicles ignition to the Key On, Engine users.
Off position and connect OBDLink SX to the
diagnostic connector (step B). The status light These resources can be accessed from our
should turn green. Yellow status light means no website: www.ScanTool.net
power on DLC; check fuses.
computer
scan tool
vehicle USB cable

B A
Thank you for your purchase!
Please consider leaving feedback on:

You might also like