Scribd
Upload
7K views

Precast Checklist

The document is a checklist used to inspect precast concrete components at various stages of manufacturing. It contains criteria to check the mould, reinforcement, tendons, embedded items, and concrete before and after casting. Inspectors verify dimensions, profiles, oil application, bar sizes and spacing, concrete cover, and that recesses, openings and lifting items are correctly positioned. After casting, components are checked for markings, defects, compaction and finishes before approval. Any non-conformances require rectification.

Uploaded by

shahrilzainul77
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
7K views

Precast Checklist

The document is a checklist used to inspect precast concrete components at various stages of manufacturing. It contains criteria to check the mould, reinforcement, tendons, embedded items, and concrete before and after casting. Inspectors verify dimensions, profiles, oil application, bar sizes and spacing, concrete cover, and that recesses, openings and lifting items are correctly positioned. After casting, components are checked for markings, defects, compaction and finishes before approval. Any non-conformances require rectification.

Uploaded by

shahrilzainul77
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
You are on page 1/ 1

PRECAST COMPONENT MANUFACTURING CHECKLIST

APPROVED BY:
Project / Package : Date of Inspection :
Contractor : Date of Casting :

Panel Marking : Location :


Mould / Pallet No. : Concrete Sampling Ref. :
Panel Type : Grade of Concrete :
Drawing Rev. No. : Name/ Signatory/Date

INSPECTION BEFORE CONCRETING INSPECTION AFTER CONCRETING


Checked by Checked by
Inspection Criteria 1st Check 2nd Check Inspection Remark Rectification Remark
PROD QAQC
MOULD Marking
1. Dimension Length
2. Profile Width
3. Mould Oil Application Height
4. Cleanliness Cleanliness
REINFORCEMENT
1. Bar Size, Number, Spacing
2. Concrete Cover
3. Starter Bar - Size, Position
STRANDS
1. Size, Number, Height
2. Stressing
CAST-IN-ITEMS
1. Half Grout Sleeve - Size, Position
2. Corrugated Sleeve - Size, Position
3. M&E Items - Size, Position
4. Inserts - Size, Position
OTHERS
1.Recesses, Opening
2.Groove Lines
3.Lifting Items

CONCRETING CONCRETE DEFECTS


1. Concrete Compaction
2. Type of Surface Finishes

Legend : = Acceptable, X = To be rectified, NA = Not Applicable CHECKED BY: ____________________________

NCR : YES / NO If yes refer to NCR S/N : _____________________________ Name/ Signatory/Date

You might also like