Scribd
Upload
167 views4 pages

How To Reinstall Hi12 WIN10 System (Dualboot)

The document provides instructions for reinstalling the Windows 10 system on a Chuwi Hi12 tablet in a dual-boot configuration using a USB flash drive. Key steps include formatting the USB drive to NTFS and extracting installation files to its root directory. The tablet is then booted from the USB drive by pressing F7 during startup to begin the 5-10 minute reinstallation process.

Uploaded by

Dian Razak Bastian
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
167 views4 pages

How To Reinstall Hi12 WIN10 System (Dualboot)

The document provides instructions for reinstalling the Windows 10 system on a Chuwi Hi12 tablet in a dual-boot configuration using a USB flash drive. Key steps include formatting the USB drive to NTFS and extracting installation files to its root directory. The tablet is then booted from the USB drive by pressing F7 during startup to begin the 5-10 minute reinstallation process.

Uploaded by

Dian Razak Bastian
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 4

How to reinstall Chuwi Hi12 Windows10 System (DualBoot)

Notice:
The battery level should be more than 50% before reinstalling the system.

Prepared Tools:
8GB USB Flash Disk, USB-OTG Cable, HUB (over 3 interfaces) and the USB
keyboard as follows:

If the tablet has 2 USB ports, the HUB is not necessary.

The first step:


Please format the USB flash disk into the format of NTFS and rename it as WINPE
as follows:
Please unrar the file as follows: (Close the antivirus software before unzipping the
image files to avoid the apps in files that are deleted.)

Please open the folder "Hi12 win10" and unzip it.


( is the meaning of the Dualboot)
Copy the sub-files to the root directory of the USB flash disk.

The second step:


Please press the power button of the tablet and simultaneously click F7of the
keyboard continuously to enter the boot mode.

Choose UEFI: SanDisk U1tra PMAP, Partition 1, click Enter to program.


When the programming is finished, the tablet will shut off automatically.

The programming will last about 5 to 10 minutes; the precise time is dependent of
Hub and U disk. The introduction is on basis of using the U disk 3.0. The
programming lasts about 5 minutes.

You might also like