Scribd
Upload
612 views

Tensile Strength Test-Grab Method

This document summarizes ASTM D 5034-95, a standard test method for determining the breaking strength and elongation of textile fabrics using a grab test. The grab test involves clamping a fabric sample and applying tension until the fabric breaks. The test can be performed dry or wet. It provides the breaking force, elongation at break, and other details about the testing conditions and equipment used. Key details like specimen size, clamp spacing, loading rate, and items to report are specified to maintain testing standards.

Uploaded by

educardx
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
612 views

Tensile Strength Test-Grab Method

This document summarizes ASTM D 5034-95, a standard test method for determining the breaking strength and elongation of textile fabrics using a grab test. The grab test involves clamping a fabric sample and applying tension until the fabric breaks. The test can be performed dry or wet. It provides the breaking force, elongation at break, and other details about the testing conditions and equipment used. Key details like specimen size, clamp spacing, loading rate, and items to report are specified to maintain testing standards.

Uploaded by

educardx
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Tensile Strength Test-Grab Test

ASTM D 5034-95 (Reapproved 2001)


Standard Test Method for Breaking Strength and Elongation of Textile
Fabrics (Grab Test)

What This Test is Used For:


This test determines the breaking strength and elongation of most textile fabrics. It is applicable
to woven, non-woven, and felted fabrics, while the modified grab test is used primarily for
woven fabrics. It is not recommended for knit fabrics because of their large amount of stretch.

Scientific Testing Requirements:


The specimens should be conditioned to moisture equilibrium as directed in ASTM D1776. This
test can be performed either wet or dry and samples should be cut in both the warp and weft
directions.

Equipment Needed:
4 X 8-10 specimen
Tensile Testing Machine (CRE is the type we will use)
Clamps and jaw faces

Procedure:
1. Prepare the machine. Clamps should be set about 3 inches apart
2. Select the force range of the testing machine for the break to occur between 10-90% of
full scale force.
3. Set the testing machine for a loading rate of 12 in/minute (unless otherwise specified).
4. Mount the specimen in the clamps as straight as possible so that the same lengthwise
yarns are gripped by both clamps
5. If specimen clips in the jaws, or breaks at the edge or in the jaws or performs markedly
below the average for the set of specimens, discard the result and take another specimen.

Report:
1. State that the specimens were tested according to ASTM D5034 Test Method.
2. The average breaking force for specimens giving acceptable breaks
3. The average percent apparent breaking elongation of acceptable specimens.
4. Number of specimens tested
5. Type of test specimen and testing machine used.
6. Maximum force obtainable in the range used for testing.
7. Pretension, if used.
8. Size of the jaw faces used.
9. Type of padding used in the jaws or any modification to the jaw faces.
10. Number of yarns in clamping area, if less than 25.
11. Average time required to break for acceptable specimens
12. What type of testing was used, conditioned or wet testing, or both.
13. If testing wet, whether allowance was made for shrinkage and whether sizing or finishes
had been removed and, if so, how.

You might also like