Scribd
Upload
207 views

Shear Lug Verification Example 2

This document provides guidelines for designing shear lugs used to anchor base plates to concrete foundations. It outlines how to calculate the shear load applied to the lug, design the lug plate based on required bearing area and dimensions, calculate the cantilever moment acting on the lug, determine lug thickness, design welds, and calculate the lug's breakout strength in shear. The design procedure involves sizing the lug to resist the shear load not resisted by friction between the base plate and foundation.

Uploaded by

Nasrul Adli
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
207 views

Shear Lug Verification Example 2

This document provides guidelines for designing shear lugs used to anchor base plates to concrete foundations. It outlines how to calculate the shear load applied to the lug, design the lug plate based on required bearing area and dimensions, calculate the cantilever moment acting on the lug, determine lug thickness, design welds, and calculate the lug's breakout strength in shear. The design procedure involves sizing the lug to resist the shear load not resisted by friction between the base plate and foundation.

Uploaded by

Nasrul Adli
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

PIP STE05121 TECHNICAL CORRECTION

Anchor Bolt Design Guide October 2006

The shear lug should be designed for the applied shear portion not resisted by friction
between the base plate and concrete foundation. Grout must completely surround the lug
plate or pipe section and must entirely fill the slot created in the concrete. When using a
pipe section, a hole approximately 2 inches in diameter should be drilled through the
base plate into the pipe section to allow grout placement and inspection to assure that
grout is filling the entire pipe section.

9.1 Calculating Shear Load Applied to Shear Lug


The applied shear load, Vapp, used to design the shear lug should be computed as
follows:
Vapp = Vua - Vf

9.2 Design Procedure for Shear Lug Plate


Design of a shear lug plate follows (for an example calculation, see Appendix
Example 3, this Practice):
a. Calculate the required bearing area for the shear lug:
Areq = Vapp / (0.85 * * fc) = 0.65
b. Determine the shear lug dimensions, assuming that bearing occurs only on
the portion of the lug below the grout level. Assume a value of W, the lug
width, on the basis of the known base plate size to find H, the total height
of the lug, including the grout thickness, G:
H = (Areq /W) + G
c. Calculate the factored cantilever end moment acting on a unit length of the
shear lug:
Mu = (Vapp/W) * (G + (H-G)/2)
d. With the value for the moment, the lug thickness can be found. The shear
lug should not be thicker than the base plate:
t = [(4 * Mu)/(0.9*fya)]0.5
e. Design weld between plate section and base plate.
f. Calculate the breakout strength of the shear lug in shear. The method
shown as follows is from ACI 349-01, Appendix B, section B.11:
Vcb = AVc*4**[fc]0.5
where
AVc = the projected area of the failure half-truncated pyramid defined
by projecting a 45-degree plane from the bearing edges of the
shear lug to the free edge. The bearing area of the shear lug
shall be excluded from the projected area.
= concrete strength reduction factor = 0.85

Page 20 of 24 Process Industry Practices

You might also like