Scribd
Upload
4K views

Davis Steering Mechanism - Introduction

The document discusses the Davis steering gear mechanism. The Davis steering gear uses sliding pairs which allows for more friction and easier wear over time. It consists of two arms fixed to stub axles to form bell crank levers pivoted at two points. A cross link is pin jointed at its ends to two sliders that are free to slide on the arms. As the steering wheel turns the cross link, the sliders push or pull on the arms to turn the front wheels left or right.

Uploaded by

AmitJaiswal
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
4K views

Davis Steering Mechanism - Introduction

The document discusses the Davis steering gear mechanism. The Davis steering gear uses sliding pairs which allows for more friction and easier wear over time. It consists of two arms fixed to stub axles to form bell crank levers pivoted at two points. A cross link is pin jointed at its ends to two sliders that are free to slide on the arms. As the steering wheel turns the cross link, the sliders push or pull on the arms to turn the front wheels left or right.

Uploaded by

AmitJaiswal
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

INTRODUCTION

DAVIS STEERING MECHANISM


The most conventional steering arrangement is to turn the front wheels using a hand
operated steering wheel which is positioned in front of the driver, via the steering column,
which may contain universal joints which may also be part of the collapsible steering
column design, to allow it to deviate somewhat from a straight line[1-2]. Other
arrangements are sometimes found on different types of vehicles, for example, a tiller or
rear wheel steering. Tracked vehicles such as tanks usually employ differential steering
that is, the tracks are made to move at differ speeds or even in opposite directions to bring
about a change of course or direction[3-5]. A Davis steering gear has sliding pairs which
means more friction and easy wearing. The gear fulfils the fundamental equation of gearing
in all the positions. However, due to easy wearing it becomes inaccurate after some time[6].
A davis steering shown in fig. consists of two arms PK and QL fixed to the stub axles PC
and QD to form two similar bell crank levers CPK and DQL pivoted at P and Q
respectively. A cross link AB, constrained to slide parallel to PQ, is pin jointed at its ends
to two sliders. The sliders S 1 and S2 are free to slide on the links PK and QL respectively.

Davis steering gear mechanism

1|Page

You might also like