CPL4 CPL4W
CPL4 CPL4W
ACCESS GATEWAY
>> Integrated optical transceiver for multimode and single mode >> Provides the best secure solution with the Fiber and Lock
optical transmission Management solution. No external media converters
are needed.
>> Four Ethernet ports >> The superior layer 2 switching and layer 3 routing features
allow service providers to efficiently deliver, through fiber optic,
innovative multimedia services such as IP TV, VoIP, fast
Internet surfing, gaming on demand and e-learning within
the domestic environment.
>> Integrated IEEE 802.11b/g access point (for CPL4W) >> Wireless home LAN avoids new cabling and gives
customers full mobility inside the house. The device is Ready
for MIMO-G BeamflexTM (supported by CPL-BF)
>> QoS management >> Provides excellent Quality of Service into a bundled voice,
data and video service environment.
>> VoIP over WLAN >> Enables Fixed to Mobile convergence services
>> Remote management through TR-069 integrated web >> Makes mass market deployment easy and quick.
page, Telnet, TFTP, DHCP,SNMP, UPnP
Telsey S.p.A. Viale dell'Industria, 1 - 31055 - Quinto di Treviso (TV) - Italy - Tel +390422377711 - Fax +390422470920 - www.telsey.com - [email protected]
Edited by Foxit PDF Editor
Copyright (c) by Foxit Software Company, 2004
For Evaluation Only.
access
acc ess ga
gate
tewway
BROADBAND INTERFACE
> Fiber Optic:
100BaseBX10, TX 1310nm/RX 1550nm, SC connector 100BaseLX, LC connector
100BaseSX10, SC connector 100BaseSX/10BASEFL, VF-45 connector
100BaseFX, MTRJ connector
DATA
Domestic LAN Interfaces > 4 Ethernet ports switch 10/100 BaseT half/full duplex autonegotiating. RJ-45 connectors
Layer 3 > NAT/PAT (RFC 1631) > Firewall
> RIPv2 > IP VPN
> Static routing
QoS > IP QoS management support
> VLAN 802. 1p, 802. 1q
Other > DHCP client/server > Supports IGM P snooping (RFC 1112)
> TFTP client > UpnP
W LAN Access Point (for CPL4W ) > IEEE 802. 11b, IEEE 802. 11g > M ultiple SSID
> QoS 802. 11e > VoIP over W LAN supported
- W M E, W M M > Ready for M IM O-G BeamflexTM
- Support of RTS/CTS protection mechanism (supported by M AGIC V+ BF)
- EDCF and HCF supported > Registration button
> Security 802. 11i (W EP - W PA - M AC filtering)
VOICE
Simultaneous Voice Calls >2
Analog Interfaces > 2 x FXS. RJ -11 connectors > REN : 5 per FXS port
> Dial mode supported: DTM F > On-Hook voltage: 48 V nominal
> Tones: customizable > Off-hook current: 22 mA nominal (other
> Ringing voltage: 35 Vrms, Sine wave > values programmable)
> Ringing frequency: 25 Hz default Terminating impedance: 600 Ohm default
(frequency and cadence programmable (other impedances programmable)
for each FXS interface) > Loop Signaling: Loop Start
VoIP Protocols > H.323 v.4, SIP RFC3261, MGCP
Properties > Echo cancellation G. 168
> Silence suppression/comfort noise generation
> M odem/fax passthrough
Disclaimer
All s tatements , technical infor mation and r ecommendations contained in this documentation have been car efully checked for r eliability;
however no r es pons ibility is as s umed for inaccur acies . The infor mation contained in this documentation is s ubject to change without notice.