MPMC@ASSMENT5
MPMC@ASSMENT5
Unit 6 - Week
5
Course
outline Week 5 Assignment
Due date for this assignment: 2018-02-28, 23:59 IST.
How to access
1) Which register pair of 8085 is NOT accepted in LDAX instruc on? 1 point
the portal
BC
Week 1
DE
Week 2 HL
All pairs are acceptable
Week 3
2) In 8085, the numbers 45H and 7EH are added. The resul ng flag se ngs will 1 point
Week 4
be as follows.
PUSH PSW
https://onlinecourses.nptel.ac.in/noc18_ec03/unit?unit=9&assessment=95 1/4
2/23/2018 Microprocessors and Microcontrollers - - Unit 6 - Week 5
DOWNLOAD PUSH B
VIDEOS PUSH C
PUSH D
6) Suppose that the stack pointer (SP) of 8085 contains 2004H. If the instruc on 1 point
"PUSH PSW" is used, the value of SP will be
2002H
2000H
2006H
2008H
7) In 8085, ALE signal is ac vated during 1 point
Code access
Data access
Both code and data accesses
Idle cycles
8) In “INR M” instruc on which register pair act as memory pointer? 1 point
BC
DE
HL
Any of BC, DE or HL
9) If A register of 8085 contains 4EH, the parity flag is 1 point
Reset
Set
Not decidable
Don't care
10)In a 8085 processor, suppose the D register contains value 2. In the following 1 point
code, how many mes is the JNZ instruc on executed?
LOOP: DCR D
JNZ LOOP
1
2
Infinity
Cannot be determined
Number of pins
On-chip debugging
Easy availability
None of the op ons men oned
12)In the bit-addressable RAM of 8051, among the byte addresses 99H and 89H 1 point
https://onlinecourses.nptel.ac.in/noc18_ec03/unit?unit=9&assessment=95 2/4
2/23/2018 Microprocessors and Microcontrollers - - Unit 6 - Week 5
00H-07H
08H-0FH
10H-17H
18H-1FH
14)If RS0 = 1 and RS1 = 0, the register bank address range is 1 point
00H-07H
08H-0FH
10H-17H
18H-1FH
15)The number of mers in an 8051 microcontroller is 1 point
2
5
1
0
4k Bytes
8k Bytes
16k Bytes
32k Bytes
8 bits
16 bits
32 bits
None of the given op ons
18)In 8051, compared to on-chip RAM loca ons, register access is 1 point
Faster
Slower
Same speed
Not comparable
19)Which of the following pins is the external data memory write strobe in 1 point
8051?
P3.4
P3.5
P3.6
P3.7
20)For ge ng input from a port bit of 8051 if a '1' is not wri en to it, reading of 1 point
which value may create problem?
0
1
Both 1 and 0
None of 1 or 0
You may submit any number of times before the due date. The final submission will be
considered for grading.
https://onlinecourses.nptel.ac.in/noc18_ec03/unit?unit=9&assessment=95 3/4
2/23/2018 Microprocessors and Microcontrollers - - Unit 6 - Week 5
Submit Answers
Funded by
Powered by
https://onlinecourses.nptel.ac.in/noc18_ec03/unit?unit=9&assessment=95 4/4