0% found this document useful (0 votes)
583 views

Inspection Report Ultrasonic Examination

This two-page ultrasonic inspection report summarizes the inspection of welds on an unspecified part. It lists the equipment used, including the UT equipment type, probes, calibration block, and couplant. It also describes the part and welds inspected, including drawings, material, surface conditions, and weld type. Test parameters are provided, such as technique, scanning method, test range, and data presentation. The second page continues the evaluation table, listing weld numbers, lengths, indications found, and whether each weld passed or failed inspection based on the acceptance criteria.
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
583 views

Inspection Report Ultrasonic Examination

This two-page ultrasonic inspection report summarizes the inspection of welds on an unspecified part. It lists the equipment used, including the UT equipment type, probes, calibration block, and couplant. It also describes the part and welds inspected, including drawings, material, surface conditions, and weld type. Test parameters are provided, such as technique, scanning method, test range, and data presentation. The second page continues the evaluation table, listing weld numbers, lengths, indications found, and whether each weld passed or failed inspection based on the acceptance criteria.
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

INSPECTION REPORT Report No. : Rev.

ULTRASONIC EXAMINATION Page No. : 1 of 2


Client : Location :
Project Name : Project No. :
Procedure No.(Rev) : Date of Test :
Reference Code : Request No. :

Equipment & Materials (parameter)


UT Equipment Type : Brand :
Model : Serial No. :

Probes No. Brand Probe Angle Actual Angle Frequency Size Wave Mode Other

Calibration Block Type : Serial No. :


Cable Type/Length : Cable Connectors :
Couplant : Special Equipment/Probe :

Part Identification & Information


DWG No. : Part No. :
Material : Part Size :
Surface Connection : Weld Process :
Surface Condition : Weld Type :

Calibration (System Performance) & Operation Parameter


Technique : Contact Immersion Pulse Echo Tru-TRNM Angle Beam Straight Beam
Scanning Method : Manual Auto Scanning Pattern/DRT. :
Test Range : Scan Overlap :
Sensitivity : Extent of Scanning :
Evaluation Level : Scanning Level :
Reference Level : Scanning Rate :
Sizing Indication : Reject Setting :
Discrimination : Restrictions :
Data Presentation : A-Scan B-Scan C-Scan

Evaluation
Acceptance Criteria :

Sketch :

Weld Identification AMP Discontinuity Size/Location Result


Indication Probe From
Welder Size Leg Level Angular Dist Form Depth Remark
Joint Number Weld length Number Angle Face Length Accept Reject
Number Ø %DAC Distance X Y Z

Note :

Authorization Examined/Evaluated By Witnessed/Approved By Witnessed/Approved By


Signature :
Name :
NDT Level :
Company :
Date :

(for Weld)
INSPECTION REPORT Report No. : 0 Rev. 0

ULTRASONIC EXAMINATION Page No. : 2 of 2


Client : Location :
Project Name : Project No. :
Procedure No.(Rev) : Date of Test :
Reference Code : Request No. :

Evaluation
Acceptance Criteria :

Weld Identification AMP Discontinuity Size/Location Result


Indication Probe From
Welder Size Leg Level Angular Dist Form Depth Remark
Joint Number Weld length Number Angle Face Length Accept Reject
Number Ø %DAC Distance X Y Z

Note:

Authorization Examined/Evaluated By Witnessed/Approved By Witnessed/Approved By


Signature :
Name :
NDT Level :
Company :
Date :

(for Weld)

You might also like