Scribd
Upload
65 views

Design Pull Rod

The document details the design of a pull rod with a 25mm diameter made of material that has a yield strength of 830MPa, modulus of elasticity of 200000MPa, and Poisson's ratio of 0.3. Calculations show the rod has a cross-sectional area of 490.87mm2 and can withstand a maximum tensile load of 30.77 metric tons resulting in a tensile stress of 615.01MPa, which is below the allowable tensile strength.

Uploaded by

SACHIN
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
65 views

Design Pull Rod

The document details the design of a pull rod with a 25mm diameter made of material that has a yield strength of 830MPa, modulus of elasticity of 200000MPa, and Poisson's ratio of 0.3. Calculations show the rod has a cross-sectional area of 490.87mm2 and can withstand a maximum tensile load of 30.77 metric tons resulting in a tensile stress of 615.01MPa, which is below the allowable tensile strength.

Uploaded by

SACHIN
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Design of Pull Rod

Diameter of Tie Rod : 25 mm


Yield Strength of Rod : 830 MPa
Modulus of Elasticity : 200000 MPa
Poission's Ratio : 0.3

Design Capacity

C/S area of the Rod : 490.87 mm²


: 407.43 kN
Alloawable Tensile Strength
: 41.53 MT
Maximum Tensile Load (From STAAD Output) : 30.77 MT
Tensile Stress on Rod : 615.01 MPa

You might also like