A REPORT ON

“THE CURRENT STATE OF SCANNER TECHNOLOGY”

DRAFTED BY

NWAOGWUGWU TOCHUKWU COLLINS

1. Introduction

The purpose of this report is to survey the current state of scanner technology and to briefly
discuss predicted advancements in the field.

By examining a range of recently published journal articles, magazine articles and internet sites
on the topic of scanners this report describes the main types of scanners in common use today
and examines their performance in relation to four criteria: resolution, bit-depth, dynamic range
and software. The report then considers the effect of further technological advances in these
four areas, as well as the deployment of new sensor technology on the future development of
scanners.

The first scanner, initially referred to as a 'reading machine', was developed in 1960 by Jacob
Rabinow, a Russian born engineer. The device could scan printed material and then compare
each character to a set of standards in a matrix using, for the first time, the "best match
principle" to determine the original message (Blatner, Fleishman and Roth 1998, p.3). This
reading machine was to form the basis for the development of current scanning, sorting and
processing machines.

An early improvement on the reading machine was the drum scanner. These scanners used a
type of scanning technology called photomultiplier tubes (PMT). Drum scanners are still used in
industry today because of the high quality images they produce. The development of smaller,
more economical scanners such as desktop scanners and scanners for domestic use followed
the drum scanner as the number of computer users increased and computer technology
advanced.

Scanners can now capture images from a wide variety of two and three dimensional sources.
These images are converted to digitised computer files that can be stored on a hard-drive or
floppy disk. With the aid of specific software, these images can then be manipulated and
enhanced by the user. It is now possible to deploy electronic acquisition to create an entire
layout (including all graphic elements) from the same computer. This means manual stripping is
no longer required (Scanners, digital cameras and photo CDs 2000). Scanners are considered
an invaluable tool for adding graphics and text to documents and have been readily adopted by
both business and domestic users.

2. How scanners work

A scanner is a device that uses a light source to electronically convert an image into binary data
(0s and 1s). This binary data can then be used to store the scanned image on a computer. A
scanner recreates an image by using small electronic components referred to as the scanner's
'eyes' (Scanner tips 2000). The type of 'eyes' used in today's scanners are charge-coupled
devices (CCD) and photomultiplier tubes (PMT). These electronic eyes measure the amount of
light reflected from individual points on the page and translate it to digital signals that
correspond to the brightness of each point (Englander 2000).

To create a file on the computer that represents a colour image, the scanner divides the image
into a grid with many individual points called pixels or picture elements (Scanner tips 2000). A
scanning head, termed a row of 'eyes', reads over the grid and assigns a number to each pixel
based on the main colour in that pixel, using green, blue and red. For example an aqua pixel
would be saved as a number to represent the proportion of blue, green and red which
represents the colour aqua (Scanners, digital cameras and photo CDs 2000).

3. Types of scanners
There are five main types of scanners in common use today: drum scanners, flatbed scanners,
sheet-fed scanners, slide scanners, and hand held scanners.

3.1 Drum scanners

Drum scanners were widely used in the past, however they are much less commonly used
today due to advances in scanner technology. As a result of their expense, these machines are
primarily used by professionals in industry, where they are considered important due to the
high-end quality image they produce and because they use PMT technology which is more
sophisticated than charge-coupled devices (CCDs) and contact image sensor's (CISs). Drum
scanners are difficult to operate and technicians operate these scanners by placing the item to
be scanned on a glass cylinder rotating at high speeds around the sensor (Sullivan 1996).

3.2 Flatbed scanners

The most popular scanners for general use are flatbed scanners. This type of scanner is highly
versatile because it is able to scan flat objects as well as small three dimensional objects. Flat-
bed scanners operate by placing the item to be scanned on a glass window while scanning
heads move underneath it. A transparency adapter is used to scan transparent originals such as
slides or x-rays, and an automatic document feeder is available for scanning large numbers of
documents (Scanner tips 2000).

3.3 Sheet-fed scanners

Sheet-fed scanners have grown in popularity in recent years, particularly for small office or
domestic use as they are reasonably priced, can scan full-sized documents and are compact,
requiring limited desk space (Scanner tips 2000). Most models of sheet-fed scanners have an
inbuilt document feeder to overcome the problem of manually feeding one sheet of paper at a
time. However the actual process or scanning with a sheet-fed scanner may result in distortion
as the image to be scanned moves over the scanning heads (Scanner tips 2000). A further
limitation of sheet-fed scanners is that they are unable to scan three dimensional objects.

3.4 Slide scanners

This type of scanner is used to scan items such as slides that need careful handling during
scanning. Unlike other scanners, the scanning heads in slide scanners do not reflect light from
the image, but rather pass light through it. This enables these scanners to produce superior
results without distortions caused by reflective light. To be able to scan small and detailed items,
these scanners have a large number of eyes on the scanning head which produces a high
quality result. Slide scanners tend to be more expensive and less versatile than flatbed and
sheet-fed scanners as they are limited to only scanning slides and film. These scanners,
however, are well suited to users requiring high quality scans of large numbers of slides
(Scanner tips 2000).

3.5 Hand held scanners

Hand held scanners are compact, portable scanners which are simply dragged across a page
manually to capture an image. These scanners are easy to use and economical to purchase;
however, their use is limited to text of up to four inches in diameter that does not require a high
resolution. For this reason, hand held scanners are unsuitable for colour images. A further
disadvantage of hand held scanners is that the user must have a steady hand when scanning or
the resulting image will be distorted (Scanner tips 2000).

4. Scanner specifications
The performance of a scanner can be examined in relation to four main criteria: resolution, bit-
depth, dynamic range and software.

4.1 Resolution
Resolution is a measure of how many pixels a scanner can sample in a given image. It is used
to describe the amount of detail in an image (Figeiredo, McIllree and Thomas 1996). Higher
resolution scanners are generally more expensive and produce superior results as they have a
greater capacity to capture detail. Scanners have two types of resolutions: optical resolution and
interpolated resolution.

Optical resolution, or hardware resolution, is a measure of how many pixels a scanner can
actually read. A current model desktop scanner typically has a resolution of 300 x 300 dots per
inch (dpi) (Anderson 1999). This means that this scanner has a scanning head with 300 sensors
per inch, so it can sample 300 dpi in one direction and 300 dpi in the other direction by stopping
the scanning head 300 times per inch in both directions. Some scanners stop the scanning
head more frequently as it moves down the page, giving an optical resolution of 300 x 600 dpi;
however, scanning more frequently in one direction does not improve the result of the scan. The
basic requirement for scanning detailed images and line art from photos or other printed
originals is an optical resolution of 600 dpi. When scanning slides and negatives the minimum
optical resolution is 1200 dpi.

Interpolated resolution measures the number of pixels a scanner is able to predict. A scanner
can turn a 300 x 300 dpi scan into a 600 x 600 dpi scan by looking in-between scanned pixels
and guessing what that spot would have looked like if it had been scanned. This prediction is
then used to insert new pixels in between the actual ones scanned. This technique is less
precise than optical resolution; however it assists in improving the enlargement of scanned
images.

4.2 Bit depth

Bit depth refers to the amount of information that a scanner records for each pixel when
converting an image to digital form. Scanners differ in the amount of data they record for each
pixel within an image. The simplest kinds of scanners only record data related to black and
white details and have a bit depth of 1 (Anderson 1999). The minimum bit depth required for
scanning photographs and documents is 24-bits, while slides, negatives or transparencies need
a scanner with at least 30-bits.

Thus for a scanner to produce a high quality scan with colour, a higher bit depth is required. In
general, current scanners have a bit depth of 24, which means that 8 bits of information can be
collected for the three primary colours used in scanning; blue, red and green (Anderson 1999).
This high resolution allows scanners to produce images close to photographic quality.

4.3 Dynamic range

Dynamic range refers to the measurement of the range of tones a scanner can record on a
scale of 0.0 to 4.0, with 0.0 being perfect white and 4.0 being perfect black. Colour flat-bed
scanners usually have a dynamic range of 2.4. A range of this measurement is unable to
provide high quality colour scans. A dynamic range of 2.8 and 3.2 is suited to professional
purposes and can be found in high-end scanners. An even higher dynamic range of 3.0 to 3.8
can be provided by drum scanners.

4.4 Software
A scanner, like any type of hardware, requires software. Typically the two most common pieces
of software provided with scanners include optical character recognition (OCR) and image
editing software. Optical character recognition software translates the information recorded in a
scan, tiny dots, into a text file which can be edited. Image editing software allows the tones and
colours of an image to be manipulated for better printing and display. Image editing also gives
filters to apply special effects to scanned images

5. Future developments
The quality of scanned images is constantly improving as characteristics such as resolution, bit-
depth and dynamic range are enhanced and further developed. More sophisticated image
editing and optical character recognition software development is also resulting in superior
quality scans. Future advances are expected to result in the incorporation of specialized
scanners into other types of technology such as the recently developed digital camera. This
device allows the user to take pictures of three-dimensional objects much like a regular camera,
except that instead of using film, the objects are scanned by the camera in a similar process to
the functioning of a flatbed scanner.

The relatively new area of sensor technology in the form of a contact image sensor (CIS) (see
Appendix 1) is expected to improve the functionality of scanners and the quality of images as it
"replaces the cumbersome optical reduction technique with a single row of sensors" (Grotta and
Wiener 1998, p. 1). Developers have already been able to produce a CIS scanner which is
thinner, lighter, more energy efficient and cheaper to manufacture than a traditional CCD base
device. However, the quality of the scan is not as good as its counterparts. Further development
of CIS technology is needed to improve image quality and colour, and to address the problem of
a limited 300 or 600 dpi.

6. Conclusion
This report has identified five types of scanners currently available. Some are primarily used for
professional purposes such as the drum scanner; others are used more broadly in the
workplace and home such as flatbed scanners and to a lesser extent sheetfed scanners.
Scanners for specialized purposes have also been identified such as slide and handheld
scanners. The performance of these scanners is dependent upon their resolution, bit-depth,
dynamic range and software. Scanners have improved significantly in recent years in terms of
weight, size, price and speed, and the replacement of CCD technology with CIS technology is
anticipated to produce further benefits to these areas as well as to scan quality. The impact of
these improvements is expected to increase the accessibility of scanner technology to a wider
range of users and its suitability for a wider range of purposes. In relation to this, the future of
scanner technology seems to point to the convergence of different technologies. Specialized
scanners are currently being incorporated into other types of technologies such as digital
cameras, printers, and photocopiers. This can be expected to continue with other forms of
technology in conjunction with further improvements to image quality, speed, price, size and
weight.
Reference list

Anderson, D. The PC Guide. [http:www.pctechguide.com/18scanners.htm].

Blatner, D., Fleishman, G. Roth, G. (1998) Real world scanning and halftones 2nd edition,
Peachpit Press, USA.

Englander, I (2000). The Architecture of computer hardware and systems software. John Wiley,
USA, p272.

Figeiredo, J. McIllree, J. Thomas, N. (1996) Introducing information technology 2nd edition

Jacaranda Press, Singapore, p145.

Grotta, D. and Weiner, S. What's now ...What's next.

[http://www.zdnet.com/pcmag/features/scanners98/intro.html] PC Magazines 20 October 1998.
8/4/00

Prepress, scanners, digital cameras and photoCDs.

[http://www.prepress.pps.com/mem/lib/ptr/scanners.html] 1998. 6/4/00

Scansoft scanner tips [http://www.scannercentral.com/scanners/tips/tips1.asp] 2000.6/4/00

Sullivan. M. Types of scanners. [http://hsdesign.com/scanning/types/types.html] 1996. 8/4/00