Scribd
Upload
487 views

Manual Chain Hoist Inspection Checklist: Health, Safety and Environment Management System

The document provides an inspection checklist for manual chain hoists. It lists the main components to check, including the structural support system, main hoist components like the chain, sheave wheel, hooks, and brakes. The checklist ensures the hoist's capacity is properly labeled and inspects over 15 points like the chain for wear, hooks and pins for damage, and drums and brakes for proper function. A thorough inspection is completed and signed off to verify safety of operation.

Uploaded by

Edward Dinesh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
487 views

Manual Chain Hoist Inspection Checklist: Health, Safety and Environment Management System

The document provides an inspection checklist for manual chain hoists. It lists the main components to check, including the structural support system, main hoist components like the chain, sheave wheel, hooks, and brakes. The checklist ensures the hoist's capacity is properly labeled and inspects over 15 points like the chain for wear, hooks and pins for damage, and drums and brakes for proper function. A thorough inspection is completed and signed off to verify safety of operation.

Uploaded by

Edward Dinesh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Health, safety and Environment Management System

Manual Chain Hoist Inspection checklist


Project: Date:

Name of the contractor : Location :

Chain Block ID/Code No: Lifting Capacity :

Maximum rated capacity stenciled on the beam :

SNO CHECK POINTS YES/OK N/A FAULT

1.Structural Support System


A. Mounting Base
B. Vertical Support Column
C. Horizontal Support Column
D. Support and Beam
2.Main Hoist
A. Clean the chain by removing any foreign material such as dirt and grease and inspect the
chain for wear using a gauge
B. Slack the chain and observe if wear exists at interlink bearing surface between the links.
C. Inspect the chain for gouges, nicks, arc burns, twisted, bent, worn or damaged links.
D. Inspect the loose end-link, loose end screw and dead end block and clevis pin on the
double reeved units.
E. Inspect sheave wheel for freedom of movement.
F. Mechanical load spring brake
H. Lower hook and throat opening measurement
I. Upper Hook
J. Hook Swivel
K. Hook Pin
L. Chain Drum
M. Guards

Note: After the inspection, lubricate the chain with a light coat of penetrating oil and graphite.

Inspected by: Name: Designation: Signature:

You might also like