Scribd
Upload
173 views

ECD Lab 7 PDF

The document describes an experiment to understand the DC analysis of a bipolar junction transistor (BJT) using a common-emitter voltage divider bias configuration. The objectives are to calculate DC bias voltages and currents theoretically without knowing beta and then to measure the actual bias point experimentally. Key steps include using an equation to calculate the transistor's AC dynamic resistance re based on change in voltage and current, setting up the circuit, measuring voltages and current, and comparing calculated and measured values.

Uploaded by

ImMalik
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
173 views

ECD Lab 7 PDF

The document describes an experiment to understand the DC analysis of a bipolar junction transistor (BJT) using a common-emitter voltage divider bias configuration. The objectives are to calculate DC bias voltages and currents theoretically without knowing beta and then to measure the actual bias point experimentally. Key steps include using an equation to calculate the transistor's AC dynamic resistance re based on change in voltage and current, setting up the circuit, measuring voltages and current, and comparing calculated and measured values.

Uploaded by

ImMalik
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Experiment 7

Observe DC analysis of Bipolar Junction Transistor (BJT)

Objective

● To understand the dc analysis of Bjt

Materials Needed
1. DC power supply
2. Bipolar junction Transistor
3. Resistor
4. Breadboard
5. Connecting leads
6. Digital multimeter (DMM)

Basic Information
For the voltage-divider DC bias configuration (see Fig 1), all DC bias voltages can be
approximately determined without knowing the exact value of transistor beta. The
transistor’s AC dynamic resistance, re can be calculated using
26(mV )
re = I E (mA)

Common-Emitter DC Bias
Figure-1

a. Calculate DC bias values for the circuit of fig-1. Record calculated values below.

(Calculated) V B = _______________

(Calculated) V E = _______________

(Calculated) V C = _______________

(Calculated) I E = _______________

Calculate re using equation

(Calculated) re = _______________

b. Wire up the circuit of fig-1. Set V cc =10V.Check the DC bias of the circuit
measuring values of

(Calculated) V B = _______________
(Calculated) V E = _______________
(Calculated) V C = _______________
Check that these value compare well with those calculated in step 1. Calculate the DC
emitter current using

I E = V E / RE

I E = _______________

Calculate the AC dynamic resistance, re


26(mV )
re = I E (mA)

re = _______________

Compare re with that calculated is step a.

Measured values

(Measured) V B = _______________

(Measured) V E = _______________
(Measured) V C = ​_______________

(Measured) I E = _______________

You might also like