Scribd
Upload
36 views

Analyzing Switch Mode Power

Analyzing Switch Mode Power seminar

Uploaded by

yugant7
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
36 views

Analyzing Switch Mode Power

Analyzing Switch Mode Power seminar

Uploaded by

yugant7
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

6/13/2018 Analyzing Switch Mode Power

Seminar:
Analyzing Switch Mode Power

When: Tues., June 19, 2018 Register for the Seminar

Time: 10:00AM - 2:00PM (Includes lunch)


Thank you for registering for our
June 19th: Analyzing Switch-
Where: Teledyne LeCroy Mode Power Seminar.
27007 Hills Tech Court
Farmington Hills, MI 48331 We look forward to seeing you.

Abstract:
The seminar covers the measurements of interest for designers of
switch-mode power conversion circuits and devices. We will review
the acquisition of voltage and current, their relationship in switch-mode
power conversion circuits, and the analysis of power device switching
losses, conduction losses, safe operating area, and dynamic on-
resistance.

The challenge is to perform accurate analysis while the power


transistor or diode is operating in the non-ground referenced primary
circuit of an off-line switch-mode power supply.

Instrumentation requirements such as overdrive recovery, high


frequency common mode rejection, and channel to channel time delay
matching will be covered.

Tools to determine a control loop’s step response to load changes using


information contained in the pulse width modulation signal and soft
start performance will be discussed. Testing line current harmonics
against industry standard EN61000 3-2 and measurements of real
power, apparent power, power factor, reactive power are included.

The seminar will be interactive. Specific applications questions for the


audience are encouraged.

Applications and Analysis Covered:


Switching Device Transitional Losses
Device Saturation Voltage, Conduction Loss, and Dynamic-On
Resistance
Device Safe Operating Area (SOA)
Improving probe and scope accuracies
Differential Probe Criteria for Power Circuits including CMRR
Upper and Lower Gate Drive Measurements
Control Loop Response Analysis
DV/DT Measurements
Power Quality including Apparent Power, Real Power, and Power
Factor
Line Current Harmonics, Conducted Emissions
Review of Methods for Making Differential Voltage
Measurements in Power Design Applications
Power Rail Integrity Analysis, Ripple, Noise, and Droop Analysis

http://go.teledynelecroy.com/l/48392/2018-05-22/6v8zzk 1/2
6/13/2018 Analyzing Switch Mode Power

Who Should Attend:


This seminar is especially targeted toward design engineers, evaluation
engineers and engineering managers involved in switch-mode power
circuit design, design verification and power device characterization.
Power supply, motor drive, (adjustable speed drives) and high
efficiency lighting circuit designers and evaluators.

Presenter: Steve Murphy


Applications Engineer at Teledyne LeCroy

Cost: FREE, registration is required to hold your seat.

PLEASE NOTE: All visitors must provide valid government photo identification prior to gaining access to a
Teledyne facility. This can be in the form of a driver's license or passport.

© 2018 Teledyne LeCroy

Privacy Policy | Site Map

http://go.teledynelecroy.com/l/48392/2018-05-22/6v8zzk 2/2

You might also like