Scribd
Upload
77 views1 page

Paper-3 (Engineering Drawing) : Indian BOE Coaching Service

The document contains a sample exam paper for the BOE Engineering Drawing test with 5 questions. Question 1 asks to draw the isometric view from given 3 views. Question 2 asks to draw the front, side and top views from a given pictorial view. Question 3 asks to draw illustrations and symbols for 10 types of welded joints. Question 4 asks to draw a sketch of a Pressure Reducing and De-superheating Station or a Flash Steam Separator. Question 5 asks to draw sketches of 2 items from a list including a fusible plug, riveted lap joint, pressure gauge and steam trap.

Uploaded by

vamsikl
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
77 views1 page

Paper-3 (Engineering Drawing) : Indian BOE Coaching Service

The document contains a sample exam paper for the BOE Engineering Drawing test with 5 questions. Question 1 asks to draw the isometric view from given 3 views. Question 2 asks to draw the front, side and top views from a given pictorial view. Question 3 asks to draw illustrations and symbols for 10 types of welded joints. Question 4 asks to draw a sketch of a Pressure Reducing and De-superheating Station or a Flash Steam Separator. Question 5 asks to draw sketches of 2 items from a list including a fusible plug, riveted lap joint, pressure gauge and steam trap.

Uploaded by

vamsikl
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Indian BOE Coaching Service

BOE Examination Test Papers-2016


Paper-3 (Engineering Drawing)
Date : 24.04.2016 Time : 01.30hrs. Max. Marks :100
Note : All the questions are compulsory. Each question has equal marks.

Q.1 : In figure-1 the three view of an object are given draw the isometric view. [20]

Figure-1 Figure-2
Q.2 : The pictorial view are given in figure-2. Draw (i) Front view (ii) any side view (iii) Top view [20].
Q.3 : Draw the Illustration along with symbols for any 10 of the following type of welded joints. [2x10=20].
(i) Fillet
(ii) Square butt
(iii) Single V Butt
(iv) Double V Butt
(v) Single U Butt
(vi) Double U Butt
(vii) Single Bevel Butt
(viii) Double Bevel Butt
(ix) Single J Butt
(x) Double J Butt
(xi) Edge
(xii) Spot
Q.4 : Draw a neat proportional sketch of PRDS[Pressure reducing & De-superheating Station] along with
showing all the connected mounting & Fittings. [20]
Or
Draw the sketch of the Flash steam separator with line diagram showing different connections and mountings
for medium steam pressure. [20]
Q.5 : Draw the neat sketch of any 2 of the followings : [2x10=20]
(i) Fusible plug
(ii) Single riveted lap joint.
(iii) Bourden type pressure gauge.
(iv) Bucket type steam trap.

website link: http://mithileshkhudawal.wix.com/boeindia


“IBCS is the Premier BOE Coaching Services in India, where dream convert into reality in very short duration”

You might also like