Scribd
Upload
1K views

E Bicycle Locking System

This project aims to prevent bicycle theft by implementing an electronic locking system that sounds an alarm if the bicycle is tampered with. The system uses a switch as a key and connects a metal wire between the bicycle tires and the circuit board. If the wire is cut or removed, the circuit will activate a siren to alert the owner. It uses few, low-cost components like an IC, resistors, capacitors, siren, LED, and lock wire to sense any disruption to the wire and set off the alarm, helping address theft in a timely manner.

Uploaded by

Allan Abobon Bulatao
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
1K views

E Bicycle Locking System

This project aims to prevent bicycle theft by implementing an electronic locking system that sounds an alarm if the bicycle is tampered with. The system uses a switch as a key and connects a metal wire between the bicycle tires and the circuit board. If the wire is cut or removed, the circuit will activate a siren to alert the owner. It uses few, low-cost components like an IC, resistors, capacitors, siren, LED, and lock wire to sense any disruption to the wire and set off the alarm, helping address theft in a timely manner.

Uploaded by

Allan Abobon Bulatao
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 3

E Bicycle Locking

System

Owning a bicycle is comes with a risk of it getting stolen away. Thus a system
which can help prevent the theft is required for theft avoidance. This project does
this task with very few components and a smart strategy that helps expose the
burglary at the time it is happening through the help of a siren.
E-Bicycle locking project works with the help of an electronic circuit having a
switch which acts as the key to the bicycle lock. A metal wire is connected to the
system in such a way that the wire goes from in between the tyre spikes and into
the system. So if someone wants to steal the bicycle, the wire has to be broken
first then only the bicycle will move. And if the wire lock is broken it is sensed by
the system to raise a siren alert. Hearing the siren the owner can get alert and try
to avoid theft from happening.
The mechanical locking of the tyre happens due to the wire. The wire used is for
demo purpose. A stronger metal pipe can be used to lock the tyre. This wire is
connected on to the system through a RCA connector. When there is a connection
the sensor IC detects it and cuts off the siren. On the contrary if there is no
connection between the locking terminals the sensing IC will connect the siren to
the supply and the siren will start ringing. In this way the theft situation can be
handled better in an early and timely manner.
Block Diagram:

Hardware Specifications :

 IC UM3561
 RCA connector
 Resistors
 Capacitors
 Siren
 LED
 Lock Wire

You might also like