Results for sample technician2014 test paper http://aa9pw.com/cgi-bin/exam2011.

cgi

Results for sample technician2014 test paper

Your answers are marked like this:

A. You got this question right, this is your correct answer.

A. You got this question wrong, this is your incorrect answer.

A. You got this question wrong, this is the correct answer.

A. You didnt answer this question but this would be the correct answer.

Subelement T0

1: T0A01
Which of the following is a safety hazard of a 12-volt storage battery?
A. Touching both terminals with the hands can cause electrical shock
B. Shorting the terminals can cause burns, fire, or an explosion
C. RF emissions from the battery
D. All of these choices are correct

2: T0B04
Which of the following is an important safety precaution to observe when putting up
an antenna tower?
A. Wear a ground strap connected to your wrist at all times
B. Insulate the base of the tower to avoid lightning strikes

1 of 13 11/2/2017, 2:33 PM
Results for sample technician2014 test paper http://aa9pw.com/cgi-bin/exam2011.cgi

C. Look for and stay clear of any overhead electrical wires

D. All of these choices are correct

3: T0C02
Which of the following frequencies has the lowest value for Maximum Permissible
Exposure limit?
A. 3.5 MHz
B. 50 MHz
C. 440 MHz
D. 1296 MHz

Subelement T1

4: T1A11
When is willful interference to other amateur radio stations permitted?
A. Only if the station being interfered with is expressing extreme religious or political
views
B. At no time
C. Only during a contest
D. At any time, amateurs are not protected from willful interference

5: T1B04
Which amateur band are you using when your station is transmitting on 146.52 MHz?
A. 2 meter band
B. 20 meter band
C. 14 meter band
D. 6 meter band

6: T1C03

2 of 13 11/2/2017, 2:33 PM
Results for sample technician2014 test paper http://aa9pw.com/cgi-bin/exam2011.cgi

What types of international communications are permitted by an FCC-licensed

amateur station?
A. Communications incidental to the purposes of the amateur service and remarks
of a personal character
B. Communications incidental to conducting business or remarks of a personal nature
C. Only communications incidental to contest exchanges, all other communications are
prohibited
D. Any communications that would be permitted by an international broadcast station

7: T1D08
In which of the following circumstances may the control operator of an amateur
station receive compensation for operating the station?
A. When engaging in communications on behalf of their employer
B. When the communication is incidental to classroom instruction at an
educational institution
C. When re-broadcasting weather alerts during a RACES net
D. When notifying other amateur operators of the availability for sale or trade of
apparatus

8: T1E04
What determines the transmitting privileges of an amateur station?
A. The frequency authorized by the frequency coordinator
B. The class of operator license held by the station licensee
C. The highest class of operator license held by anyone on the premises
D. The class of operator license held by the control operator

9: T1F13
When must the station licensee make the station and its records available for FCC
inspection?
A. At any time ten days after notification by the FCC of such an inspection
B. At any time upon request by an FCC representative
C. Only after failing to comply with an FCC notice of violation

3 of 13 11/2/2017, 2:33 PM
Results for sample technician2014 test paper http://aa9pw.com/cgi-bin/exam2011.cgi

D. Only when presented with a valid warrant by an FCC official or government agent

Subelement T2

10: T2A03
What is a common repeater frequency offset in the 70 cm band?
A. Plus or minus 5 MHz
B. Plus or minus 600 kHz
C. Minus 600 kHz
D. Plus 600 kHz

11: T2B02
What is the term used to describe the use of a sub-audible tone transmitted with
normal voice audio to open the squelch of a receiver?
A. Carrier squelch
B. Tone burst
C. DTMF
D. CTCSS

12: T2C08
Which of the following is a characteristic of good emergency traffic handling?
A. Passing messages exactly as received
B. Making decisions as to whether or not messages should be relayed or delivered
C. Communicating messages to the news media for broadcast outside the disaster area
D. All of these choices are correct

4 of 13 11/2/2017, 2:33 PM
Results for sample technician2014 test paper http://aa9pw.com/cgi-bin/exam2011.cgi

Subelement T3

13: T3A01
What should you do if another operator reports that your station s 2 meter signals
were strong just a moment ago, but now they are weak or distorted?
A. Change the batteries in your radio to a different type
B. Turn on the CTCSS tone
C. Ask the other operator to adjust his squelch control
D. Try moving a few feet or changing the direction of your antenna if possible, as
reflections may be causing multi-path distortion

14: T3B10
What frequency range is referred to as HF?
A. 300 to 3000 MHz
B. 30 to 300 MHz
C. 3 to 30 MHz
D. 300 to 3000 kHz

15: T3C07
What band is best suited for communicating via meteor scatter?
A. 10 meters
B. 6 meters
C. 2 meters
D. 70 cm

Subelement T4

5 of 13 11/2/2017, 2:33 PM
Results for sample technician2014 test paper http://aa9pw.com/cgi-bin/exam2011.cgi

16: T4A06
Which of the following would be connected between a transceiver and computer in a
packet radio station?
A. Transmatch
B. Mixer
C. Terminal node controller
D. Antenna

17: T4B12
What is the function of automatic gain control or AGC?
A. To keep received audio relatively constant
B. To protect an antenna from lightning
C. To eliminate RF on the station cabling
D. An asymmetric goniometer control used for antenna matching

Subelement T5

18: T5A01
Electrical current is measured in which of the following units?
A. Volts
B. Watts
C. Ohms
D. Amperes

19: T5B12
Which of the following frequencies is equal to 28,400 kHz?
A. 28.400 MHz
B. 2.800 MHz
C. 284.00 MHz

6 of 13 11/2/2017, 2:33 PM
Results for sample technician2014 test paper http://aa9pw.com/cgi-bin/exam2011.cgi

D. 28.400 kHz

20: T5C05
What is the unit of frequency?
A. Hertz
B. Henry
C. Farad
D. Tesla

21: T5D10
What is the voltage across a 2-ohm resistor if a current of 0.5 amperes flows through
it?
A. 1 volt
B. 0.25 volts
C. 2.5 volts
D. 1.5 volts

Subelement T6

22: T6A03
What electrical parameter is controlled by a potentiometer?
A. Inductance
B. Resistance
C. Capacitance
D. Field strength

23: T6B01
What class of electronic components is capable of using a voltage or current signal
to control current flow?

7 of 13 11/2/2017, 2:33 PM
Results for sample technician2014 test paper http://aa9pw.com/cgi-bin/exam2011.cgi

A. Capacitors
B. Inductors
C. Resistors
D. Transistors

24: T6C11
What is component 4 in figure T3?
A. Antenna
B. Transmitter
C. Dummy load
D. Ground

8 of 13 11/2/2017, 2:33 PM
Results for sample technician2014 test paper http://aa9pw.com/cgi-bin/exam2011.cgi

25: T6D02
What best describes a relay?
A. A switch controlled by an electromagnet
B. A current controlled amplifier
C. An optical sensor
D. A pass transistor

9 of 13 11/2/2017, 2:33 PM
Results for sample technician2014 test paper http://aa9pw.com/cgi-bin/exam2011.cgi

Subelement T7

26: T7A11
Where is an RF preamplifier installed?
A. Between the antenna and receiver
B. At the output of the transmitter's power amplifier
C. Between a transmitter and antenna tuner
D. At the receiver's audio output

27: T7B12
What might be the first step to resolve cable TV interference from your ham radio
transmission?
A. Add a low pass filter to the TV antenna input
B. Add a high pass filter to the TV antenna input
C. Add a preamplifier to the TV antenna input
D. Be sure all TV coaxial connectors are installed properly

28: T7C01
What is the primary purpose of a dummy load?
A. To prevent the radiation of signals when making tests
B. To prevent over-modulation of your transmitter
C. To improve the radiation from your antenna
D. To improve the signal to noise ratio of your receiver

29: T7D12
Which of the following precautions should be taken when measuring high voltages
with a voltmeter?
A. Ensure that the voltmeter has very low impedance
B. Ensure that the voltmeter and leads are rated for use at the voltages to be

10 of 13 11/2/2017, 2:33 PM
Results for sample technician2014 test paper http://aa9pw.com/cgi-bin/exam2011.cgi

measured
C. Ensure that the circuit is grounded through the voltmeter
D. Ensure that the voltmeter is set to the correct frequency

Subelement T8

30: T8A08
What is the approximate bandwidth of a single sideband voice signal?
A. 1 kHz
B. 3 kHz
C. 6 kHz
D. 15 kHz

31: T8B04
Which amateur stations may make contact with an amateur station on the
International Space Station using 2 meter and 70 cm band amateur radio
frequencies?
A. Only members of amateur radio clubs at NASA facilities
B. Any amateur holding a Technician or higher class license
C. Only the astronaut's family members who are hams
D. You cannot talk to the ISS on amateur radio frequencies

32: T8C04
Which of the following is good procedure when contacting another station in a radio
contest?
A. Be sure to sign only the last two letters of your call if there is a pileup calling the station
B. Work the station twice to be sure that you are in his log
C. Send only the minimum information needed for proper identification and the
contest exchange

11 of 13 11/2/2017, 2:33 PM
Results for sample technician2014 test paper http://aa9pw.com/cgi-bin/exam2011.cgi

D. All of these choices are correct

33: T8D01
Which of the following is an example of a digital communications method?
A. Packet
B. PSK31
C. MFSK
D. All of these choices are correct

Subelement T9

34: T9A05
How would you change a dipole antenna to make it resonant on a higher frequency?
A. Lengthen it
B. Insert coils in series with radiating wires
C. Shorten it
D. Add capacitive loading to the ends of the radiating wires

35: T9B06
Which of the following connectors is most suitable for frequencies above 400 MHz?
A. A UHF (PL-259/SO-239) connector
B. A Type N connector
C. An RS-213 connector
D. A DB-25 connector

Results:
You scored 25 correct answers and 10 incorrect answers from a total of 35.

Unfortunately, you had 10 wrong answers and you are only allowed 9.

12 of 13 11/2/2017, 2:33 PM
Results for sample technician2014 test paper http://aa9pw.com/cgi-bin/exam2011.cgi

exam

Click here to take another test.

Please mail any comments to me, Simon AA9PW, I appreciate your feedback. If you Like the site, please
Like us on Facebook!

13 of 13 11/2/2017, 2:33 PM