Scribd
Upload
19 views

ER650C9F - D9F Cluster

This document provides instructions for inspecting and testing an electronic combination meter unit on a vehicle. It describes removing the meter assembly and cover. It then lists the terminal connections on the meter unit and gives warnings to not drop the unit and not short the terminals. Finally, it provides steps to perform a LCD segment check by connecting a 12V battery to specific terminals on the meter unit connector.

Uploaded by

jackass_t
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
19 views

ER650C9F - D9F Cluster

This document provides instructions for inspecting and testing an electronic combination meter unit on a vehicle. It describes removing the meter assembly and cover. It then lists the terminal connections on the meter unit and gives warnings to not drop the unit and not short the terminals. Finally, it provides steps to perform a LCD segment check by connecting a 12V battery to specific terminals on the meter unit connector.

Uploaded by

jackass_t
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

ELECTRICAL SYSTEM 16-65

Meter, Gauge, Indicator Unit

• Separate
[B].
the meter assembly [A] and upper meter cover

Electronic Combination Meter Unit Inspection


• Remove the meter unit [A] (see Meter Unit Removal).
[1] Battery (+)
[2] Ignition
[3] Ground (–)
[4] Speed Sensor Supply Voltage
[5] Speed Sensor Signal
[6] Tachometer Signal
[7] Fuel Level Gauge
[8] Fuel Reserve Switch
[9] FI Indicator Light (LED) (–)
[10] Water Temperature Sensor (–)
[11] High Beam Indicator Light (LED) (+)
[12] Left Turn Signal Indicator Light (LED) (+)
[13] Right Turn Signal Indicator Light (LED) (+)
[14] Neutral Indicator Light (LED) (–)
[15] Oil Pressure Warning Indicator Light (LED) (–)
[16] ABS Indicator Light (LED) (–) (ER650D Models)

CAUTION
Do not drop the meter unit. Place the meter unit so
that it faces upward. If the meter unit is left upside
down or sideways for a long time or dropped, it will
malfunction. Do not short each terminals.
Liquid Crystal Display (LCD) Segment Check
• Using the auxiliary leads, connect the 12 V battery to the
meter unit connector as follows.
żConnect the battery positive terminal to the terminal [1].
żConnect the battery negative terminal to the terminal [3].
żAnything does not happen, it is normal.

You might also like