Scribd
Upload
366 views

Draw The Cam Profile For Following Conditions

The cam profile is for a roller follower offset 5mm to the right of the cam shaft. The lift is 30mm over 120 degrees of cam rotation for the out stroke with SHM. It dwells for 600 degrees, then the return stroke occurs over 1200 degrees with the first half at uniform velocity and the second half with UARM. It dwells for the remaining period. The displacement diagram and cam profile are to be drawn.

Uploaded by

maloy
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
366 views

Draw The Cam Profile For Following Conditions

The cam profile is for a roller follower offset 5mm to the right of the cam shaft. The lift is 30mm over 120 degrees of cam rotation for the out stroke with SHM. It dwells for 600 degrees, then the return stroke occurs over 1200 degrees with the first half at uniform velocity and the second half with UARM. It dwells for the remaining period. The displacement diagram and cam profile are to be drawn.

Uploaded by

maloy
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

(11) Draw the cam profile for following conditions:

Follower type = roller follower, off-set to the right by 5mm; lift = 30mm; base circle radius =
25mm; roller radius = 5mm; out stroke with SHM, for 120 0 cam rotation; dwell for 600 cam
rotation; return stroke during 1200 cam rotation; first half of return stroke with Uniform velocity
and second half with UARM; dwell for the remaining period.
Displacement diagram:

Cam profile:
(12) A push rod of valve of an IC engine ascends with UARM, along a path inclined to the vertical
at 600. The same descends with SHM. The base circle diameter of the cam is 50mm and the push
rod has a roller of 60mm diameter, fitted to its end. The axis of the roller and the cam fall on the
same vertical line. The stroke of the follower is 20mm. The angle of action for the outstroke and
the return stroke is 600 each, interposed by a dwell period of 600. Draw the profile of the cam.
Displacement diagram:

Cam profile:

You might also like