Scribd
Upload
41 views

Details of Joint Groove For Transverse Joints: Detail Detail

1. The document provides details on joint grooves for transverse joints in concrete slabs, including contraction joints, expansion joints, and isolation joints. 2. It specifies the width and depth of joint grooves based on the joint spacing, and includes four detail drawings showing configurations for reinforced and unreinforced slabs. 3. Notes provide guidance that the initial saw cut can be omitted for non-cast-through slabs, and that sealant and bond breaker tape depth should follow manufacturer recommendations.

Uploaded by

marcol99
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
41 views

Details of Joint Groove For Transverse Joints: Detail Detail

1. The document provides details on joint grooves for transverse joints in concrete slabs, including contraction joints, expansion joints, and isolation joints. 2. It specifies the width and depth of joint grooves based on the joint spacing, and includes four detail drawings showing configurations for reinforced and unreinforced slabs. 3. Notes provide guidance that the initial saw cut can be omitted for non-cast-through slabs, and that sealant and bond breaker tape depth should follow manufacturer recommendations.

Uploaded by

marcol99
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

approx.

5 ±1

sealant
' .. •
,.
'. Bond breaker tape
1.------ Leave Initial
saw cut as void ,. Leave as void

J 3mm approx.
(see Note 1)

DETAIL A DETAIL B
(Contraction Joint for reinforced slabs) (Contraction Joint for unrein forced slobs)

Width Depth
Joint spacing W D
(m) (mm) (mm)

Joint spacing ~ 10 10

10 ( Joint spacing ~ 15 See


20
Note 2
15 ( Joint spacing ~ 20 25

(FOR DETAIL A ONLY)

5 ± 1 mrrl-~
5 ± 1 mm

f--~----- Joint sealant - - - - - - -

---Borld breaker tope

.' .. - - - - - Joint filler ------

j LlOmm

DETAIL c DETAIL D
(Expansion Joint> (Isolation Joint)

Notes:
1. Initial saw cut sholl be omitted when
slabs are not cast through the joint. A General Revision June 04
2. The depth of the joint sealant and bond
Former Drg. No. H1004A with general
breaker tape shall be in accordance with June 94
revision
the manufacturer's recommendations.
REF. REVISION SIGNATUR DATE

HIGHWA YS DEPARTMENT
DETAILS OF
REFERENCE DRAWING No. CAD
JOINT GROOVE FOR
TRANSVERSE JOINTS SCALE
DIAGRAMMATIC
H l109A

You might also like