Scribd
Upload
138 views2 pages

Sanko Anchor Installation Instructions

The document outlines a 6-step procedure for installing Sanko concrete anchors, including obtaining the proper setting tool for the anchor size, drilling a hole to the specified depth and cleaning it, checking the hole depth, inserting the anchor, using the setting tool to fully seat the anchor, and verifying proper installation.

Uploaded by

Ferdinand Ramos Espiritu
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
138 views2 pages

Sanko Anchor Installation Instructions

The document outlines a 6-step procedure for installing Sanko concrete anchors, including obtaining the proper setting tool for the anchor size, drilling a hole to the specified depth and cleaning it, checking the hole depth, inserting the anchor, using the setting tool to fully seat the anchor, and verifying proper installation.

Uploaded by

Ferdinand Ramos Espiritu
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Sanko Anchor Installation Procedure (CT-3040U, CT-4050U)

Step 1 Obtain the proper setting tool for the


anchor size being installed.

• For the 3/8” CT-3040U use the


HT-3040
• For the 1/2” CT-4050U use the
HT-4050

Step 2 Drill a hole in the concrete. Space


anchors at least 3 ½” apart from each
other and 3 ½” from the edge of the
concrete.

• CT-3040U: Use a 1/2” diameter


drill bit to a depth of 1 9/16”.
• CT-4050U: Use a 5/8” diameter
drill bit to a depth of 2”.

Step 3 Clean debris in the drilled anchor hole


before setting the anchor. Any debris still
present in the hole when the anchor is set
could reduce the holding power of the
anchor.

P.O. Box 68 • Morristown, AZ 85342


p 800.677.3933 • f 800.684.0788 • www.ccinetwork.com
Sanko Anchor Installation Procedure (CT-3040U, CT-4050U)
Step 4 Make sure the hole is the proper depth.
This can be checked by inserting the
setting tool into the hole and checking to
see if the shoulder of the setting tool is
level with the surface of the concrete.

Step 5 Insert the anchor into the hole. A hammer


may be used to gently tap the anchor into
place.

Step 6 Place the small end of the setting tool into


the anchor. Use a hammer to strike the
setting tool until the shoulder of the
setting tool is level with the top of the
anchor. The anchor is now properly
installed.

P.O. Box 68 • Morristown, AZ 85342


p 800.677.3933 • f 800.684.0788 • www.ccinetwork.com

You might also like