Scribd
Upload
111 views2 pages

Embedded Password Based Security Door Lock System Using I2C Protocol

This document describes an embedded password-based security door lock system using I2C protocol that allows only authorized persons to access restricted areas. The system uses a numeric keypad to enter a user ID and password which operates a stepper motor to unlock a solenoid-operated lock for a preset time. If an incorrect code is entered three times, the system locks down. An administrator password can override a forgotten user password. The system provides audio feedback for key presses and runs on a 5V power supply.

Uploaded by

Jiiva Gopi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
111 views2 pages

Embedded Password Based Security Door Lock System Using I2C Protocol

This document describes an embedded password-based security door lock system using I2C protocol that allows only authorized persons to access restricted areas. The system uses a numeric keypad to enter a user ID and password which operates a stepper motor to unlock a solenoid-operated lock for a preset time. If an incorrect code is entered three times, the system locks down. An administrator password can override a forgotten user password. The system provides audio feedback for key presses and runs on a 5V power supply.

Uploaded by

Jiiva Gopi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 2

Embedded Password Based Security Door Lock

System Using I2C Protocol

Security is prime concern in our day-to-day life. Every one wants to be as much as
secure as to be possible. An access control systems forms a vital link in a security chain.
The micro controller based digital lock presented here is an access control system that
allows only authorized persons to access a restricted area. This system is best suitable for
corporate offices, ATMs and home security.

The system comprises a small electronic unit with a numeric keypad, which is
fixed out side the entry door to control a solenoid-operated lock with the help of a stepper
motor. When an authorized person enters predetermined user ID and password via the
keypad, the stepper motor is operated for a limited time to unlatch the solenoid-operated
lock so the door can be open. At the end of preset delay, the stepper motor is operated in
reverse direction and the door gets locked again.

When the code has been incorrectly entered three times in a row, the code lock
will switch to block mode. This function thwarts any attempt by ‘hackers’ to quickly try a
large number of codes in a sequence. If the user forgets his password, the code lock can
be accessed by a unique 10 digit administrator password. The secret code can be changed
any time after entering the current code (Master code).

A buzzer is provided for audio acknowledgment of the key impression. Whenever


a key is pressed on the numeric key pad, the system acknowledges the impression by a
short beep sound. This buzzer is driven by an NPN transistor.

This project uses regulated 5V, 500mA power supply. 7805 three terminal voltage
regulator is used for voltage regulation. Bridge type full wave rectifier is used to rectify
the ac out put of secondary of 230/12V step down transformer.

You might also like