Scribd
Upload
79 views3 pages

B31.3, Paragraph 304.5.3: DG 24 e 1 P 16 232.0608 S 23200 W 1

This document contains calculations to determine the required thickness (Tm) of a material based on its inside diameter (dg), quality factor (e), internal design pressure (P), material stress value (S), and weld joint strength reduction factor (w). It lists the values used in the calculation: dg = 16, e = 1, P = 16,232.06, S = 23,200, w = 1. It then shows the calculation: Tm = dg * ((3*P /16*SE) + c)^0.5, which equals 0.177413105.

Uploaded by

Subbu Pemmasani
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
79 views3 pages

B31.3, Paragraph 304.5.3: DG 24 e 1 P 16 232.0608 S 23200 W 1

This document contains calculations to determine the required thickness (Tm) of a material based on its inside diameter (dg), quality factor (e), internal design pressure (P), material stress value (S), and weld joint strength reduction factor (w). It lists the values used in the calculation: dg = 16, e = 1, P = 16,232.06, S = 23,200, w = 1. It then shows the calculation: Tm = dg * ((3*P /16*SE) + c)^0.5, which equals 0.177413105.

Uploaded by

Subbu Pemmasani
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
You are on page 1/ 3

B31.3, paragraph 304.5.3 Tm = dg * ((3*P /16*SE) + c)^0.

dg 24
e 1
p 16 232.0608
s 23200
w 1

3p/16se
0.001875

0.043307 1.039367 26.39991


p w
dg e (internal s (weld joint Corrosion
(inside (quality design Material (stress value strength reduction Allowance
diameter) factor) gage for material) factor)
pressure)

16 1 12 A283 C 18300 1
tm (Thickness
required)

0.177413105 Tm = dg * ((3*P /16*SE) + c)^0.5

You might also like