Scribd
Upload
660 views1 page

LAB 2 Half Wave Rectifier

This document describes a lab experiment on analyzing a half-wave rectifier circuit with a freewheeling diode. The objectives are to analyze the working and performance of the circuit, observe the effect of the freewheeling diode, and perform a simulation. The procedure involves simulating the circuit in Proteus and observing waveforms for current, diode voltage, inductor voltage, and output voltage. Results and analysis of the waveforms are presented to demonstrate the working principle and effects of adding the freewheeling diode to the rectifier circuit.

Uploaded by

syahmimisahfani
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
660 views1 page

LAB 2 Half Wave Rectifier

This document describes a lab experiment on analyzing a half-wave rectifier circuit with a freewheeling diode. The objectives are to analyze the working and performance of the circuit, observe the effect of the freewheeling diode, and perform a simulation. The procedure involves simulating the circuit in Proteus and observing waveforms for current, diode voltage, inductor voltage, and output voltage. Results and analysis of the waveforms are presented to demonstrate the working principle and effects of adding the freewheeling diode to the rectifier circuit.

Uploaded by

syahmimisahfani
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

DJM 5103

POWER ELECTRONIC

LAB 2 : HALF WAVE RECTIFIER WITH THE USE OF FREE-WHEELING DIODE

Objectives:
1. To analyze the working and performance of single phase half wave uncontrolled rectifier with
freewheeling diode
2. To observe the effect of free-wheeling diode in the circuit.
3. To perform simulation using Proteus software.

Equipment:
Proteus simulation software, AC supply, diode, resistors, inductor coil, oscilloscope, multi-meter

Introduction:
….(write down theory of rectifier)…

Work procedure:
…(write down your lab procedure)….

Result & Analysis:


Arrange the circuit as shown with free-wheeling diode Dm is added to the circuit. Simulate the circuit
using Proteus software and observe the waveform of i, voltage across diode VR, VL and Vo. Use parameter
values: R = 1.5kΩ, L = 3H, amplitude of V = 24V, frequency f = 50Hz, diode voltage drop = 0.7V

a) Result:
Output current, io Voltage across resistor, VR Voltage across inductor, VL Output voltage, Vo

b) Waveform:
i. io waveform:

ii. Vout waveform:

Observation:
i. Present all the waveform and explain the working principle of rectifier with FWD added
ii. Make observations on what you have learned throughout your experiment

Conclusion:
Make a conclusion for this experiment

You might also like