Scribd
Upload
130 views2 pages

Rain Sensor Module

The rain sensor module detects rainfall through a rain board and control board. It uses a comparator to output a digital signal and analog voltage to indicate rainfall amount. The module has a 5cm x 4cm nickel-plated rain board, works on 5V power, and its sensitivity can be adjusted through a potentiometer.

Uploaded by

nirikshith p
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
130 views2 pages

Rain Sensor Module

The rain sensor module detects rainfall through a rain board and control board. It uses a comparator to output a digital signal and analog voltage to indicate rainfall amount. The module has a 5cm x 4cm nickel-plated rain board, works on 5V power, and its sensitivity can be adjusted through a potentiometer.

Uploaded by

nirikshith p
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

RAIN SENSOR MODULE

DESCRIPTION:

The rain sensor module is an easy tool for rain detection. It can be used as a switch
when raindrop falls through the raining board and also for measuring rainfall intensity.
The module features, a rain board and the control board that is separate for more
convenience, power indicator LED and an adjustable sensitivity though a potentiometer.

The analog output is used in detection of drops in the amount of rainfall. Connected
to 5V power supply, the LED will turn on when induction board has no rain drop, and DO
output is high. When dropping a little amount water, DO output is low, the switch indicator
will turn on. Brush off the water droplets, and when restored to the initial state, outputs
high level.

SPECIFICATIONS:

 Adopts high quality of RF-04 double sided material.


 Area: 5cm x 4cm nickel plate on side,
 Anti-oxidation, anti-conductivity, with long use time;
 Comparator output signal clean waveform is good, driving ability, over 15mA;
 Potentiometer adjust the sensitivity;
 Working voltage 5V;
 Output format: Digital switching output (0 and 1) and analog voltage output AO;
 With bolt holes for easy installation;
 Small board PCB size: 3.2cm x 1.4cm;
 Uses a wide voltage LM393 comparator

PIN CONFIGURATION:

1. VCC: 5V DC

2. GND: ground

3. DO: high/low output

4. AO: analog output

You might also like