-•-• --•- - •• • ••• - • - - • •• - • ••• • -•

The Icom IC-7700

A New Top-class HF/6m Transceiver

Adam Farson
VA7OJ
IC-7700 Information & Links

Copyright © 2008 North Shore Amateur Radio Club

16 October 2008 NSARC HF Operators – IC-7700 1

IC-7700 front panel

-•-• --•- - •• • ••• - • - - • •• - • ••• • -•

This is a big radio. 425(W) x 149 (H) x 437 (D) mm, 22.5 kg.

16 October 2008 NSARC HF Operators – IC-7700 2

IC-7700 rear panel

-•-• --•- - •• • ••• - • - - • •• - • ••• • -•

16 October 2008 NSARC HF Operators – IC-7700 3

IC-7700: Main Points

-•-• --•- - •• • ••• - • - - • •• - • ••• • -•

! Single, no-compromise receiver: +40 dBm IP3 at 50 kHz offset
" Front end similar to IC-7800, with improved strong-signal handling
" Large RF BPF inductors, “Digisel” tracking preselector, 2 linear low-noise preamps, DMOS 1st mixer
" All front-end RF circuits relay-switched to eliminate switching-diode IMD
" Dedicated high-performance 6m front end optimized for that band
! Rugged 200W MOSFET transmitter
" PA stage utilizes a pair of MRF150 MOSFETs (VDD = 48V)
" Delivers 200W in all modes, at full duty cycle
" Comprehensive VSWR and thermal protection
" Full metering: PO, VDD, ID, ALC, SWR, temperature
" Up-converting architecture: 36 kHz DSP IF 455 kHz 64.455 MHz TX freq.
! Internal high-speed automatic antenna tuner
" Covers HF and 6m bands
! Quiet, internal switch-mode mains PSU
" Adapts automatically to mains voltage 85 – 265V, 50/60 Hz
! Selectable 15, 6 & 3 kHz roofing filters
" MCF’s optimized for low passive IMD, mounted on plug-in daughter-boards
! Precision 10 MHz OCXO with 5 x 10-8 frequency stability
" The precision OCXO with 10 MHz REF I/O port allows the IC-7700 to clock other equipment, or to be
clocked from a higher-level master clock source

16 October 2008 NSARC HF Operators – IC-7700 4

IC-7700: Main Points (cont.)

-•-• --•- - •• • ••• - • - - • •• - • ••• • -•

! Two independent DSP units
" One DSP (TI TMS320C6727) is dedicated to the transmitter and receiver, and the other (TI
TMS320C6720) to the spectrum scope. These are of a later generation than the TMS320C6713 used
in the IC-7800.
! 7” color TFT LCD display (800 x 400 pixels)
" The display includes a simulated analogue multi-function meter
" Rear-panel VGA port for external video monitor
! Multi-function spectrum scope with selectable RBW
" Selectable resolution bandwidth (min. RBW = 100 Hz) permits spectral analysis of received signals
" Displays span centered on RX frequency (CENT) or a defined frequency range (FIX)
" IMD products and spurs can be displayed
" Displays spectrum of transmitted signal
! Built-in RTTY/PSK31 modem requiring only a USB keyboard
" The built-in RTTY/PSK31 modem allows use of the IC-7700 as a complete digimode terminal,
requiring only a keyboard. This is great for semi-portable operation (e.g. Field Day) or when shack
space is at a premium. FFT spectral, waterfall and vector tuning aids are provided.
! Comprehensive IF-DSP selectivity filtering for all modes
" Continuously-adjustable bandwidth, selectable shape factors, optimized defaults for each mode
" Twin Passband Tuning allows independent adjustment of lower & upper passband flanks
! IF-DSP dual-loop AGC
" AGC decay times selectable via menu or adjustable via front-panel control
" Excellent transient response, without clamping

16 October 2008 NSARC HF Operators – IC-7700 5

IC-7700: Additional Features

-•-• --•- - •• • ••• - • - - • •• - • ••• • -•

! IF-DSP manual notch filter with adjustable parameters
" The manual notch filter shape factor is selectable in 3 steps, and its maximum stopband attenuation is
70 dB. The manual notch is within the AGC loop.
! IF-DSP auto-notch filter
" Auto-notch is post-AGC, and suppresses single or multiple tones
! High-performance IF-DSP noise blanker (NB)
" NB is DSP process ahead of AGC derivation point
" NB suppresses single or periodic impulsive RF events before they can cause AGC activity
" Adjustable threshold (front-panel control), blank depth & width (menu)
! IF-DSP noise reduction (NR)
" Does correlation discrimination on noise vs. signal; computes out noise
" 16 levels, adjustable via front-panel control
" Post-AGC; heuristic (“learns” prevailing noise condition)
! IF-DSP CW Audio Peak Filter (APF) and RTTY Twin Peak Filter (TPF)
" CW APF is tunable; 3 bandwidth settings available
" TPF passes RTTY mark & space tones
! High-quality digital voice recorder
" Record off-air or from microphone; play mic recordings on-air
" Load/save .WAV files

16 October 2008 NSARC HF Operators – IC-7700 6

IC-7700: Additional Features
(cont.)

-•-• --•- - •• • ••• - • - - • •• - • ••• • -•

! Front-panel USB ports for USB memory drive & keyboard
" Load/save Digital Recorder .WAV files, configuration settings, RTTY/PSK31 text
" Upload new system firmware (alternately via rear-panel Ethernet port)
! DSP-derived transmit monitor
" Samples transmit IF signal
" Accurately reproduces transmitted SSB, AM and FM signal
! Dual VFO’s with one-button Split
" Allows rapid switch-over to Split mode
! One-button XFC (TX frequency check)
" Permits monitoring of transmit frequency in Split mode
! Voice-activated squelch control (VSC)
" Responds to speech signals only
" Usable in SSB, AM and FM modes
! S/P-DIF optical digital baseband interface
" Optical digital interface for baseband input/output in digital domain
" Connect external audio devices with integral codec for highest audio quality

16 October 2008 NSARC HF Operators – IC-7700 7

Evolution of TI DSP family
as used in the IC-7700

-•-• --•- - •• • ••• - • - - • •• - • ••• • -•

16 October 2008 NSARC HF Operators – IC-7700 8

IC-7700 Screen Display
Spectrum Scope: ± 2.5 kHz span, 100 Hz RBW

-•-• --•- - •• • ••• - • - - • •• - • ••• • -•

BW: IF Bandwidth
SFT: Passband Shift
BPF: Tight Shape Factor
F-BKIN: QSK

16 October 2008 NSARC HF Operators – IC-7700 9

IC-7700 RTTY & PSK31 Displays
RTTY & PSK31 TX/RX text fields & tuning aids

-•-• --•- - •• • ••• - • - - • •• - • ••• • -•

RTTY PSK31

RTTY Decoder Setup Menu

16 October 2008 NSARC HF Operators – IC-7700 10

IC-7700 Receiver
Simplified Block Diagram

-•-• --•- - •• • ••• - • - - • •• - • ••• • -•

16 October 2008 NSARC HF Operators – IC-7700 11

IC-7700 Interior View
Chassis underside

-•-• --•- - •• • ••• - • - - • •• - • ••• • -•

16 October 2008 NSARC HF Operators – IC-7700 12

IC-7700 Interior View
Chassis top side, showing airflow

-•-• --•- - •• • ••• - • - - • •• - • ••• • -•

PA

PSU ATU

SPKR

16 October 2008 NSARC HF Operators – IC-7700 13

IC-7700 Automatic ATU

-•-• --•- - •• • ••• - • - - • •• - • ••• • -•

16 October 2008 NSARC HF Operators – IC-7700 14

IC-7700 RX BPF Unit
Note filter selection relays & large toroid cores

-•-• --•- - •• • ••• - • - - • •• - • ••• • -•

16 October 2008 NSARC HF Operators – IC-7700 15

IC-7700 Digisel Preselector
and characteristics at 14 MHz

-•-• --•- - •• • ••• - • - - • •• - • ••• • -•

16 October 2008 NSARC HF Operators – IC-7700 16

IC-7700 200W PA Unit
showing heatsink and MRF150 PA devices

-•-• --•- - •• • ••• - • - - • •• - • ••• • -•

16 October 2008 NSARC HF Operators – IC-7700 17

IC-7700 10 MHz OCXO
Stability: 5 x 10-8

-•-• --•- - •• • ••• - • - - • •• - • ••• • -•

16 October 2008 NSARC HF Operators – IC-7700 18

IC-7700 Component Details

-•-• --•- - •• • ••• - • - - • •• - • ••• • -•

BPF coil detail

RF relay with bifurcated noble-metal contacts

TX/RX DSP IC (250 MHz clock)

16 October 2008 NSARC HF Operators – IC-7700 19

IC-7700 Roofing Filter Group
WIDE 15 kHz, MIDDLE 6 kHz, NARROW 3 kHz

-•-• --•- - •• • ••• - • - - • •• - • ••• • -•

The MCF roofing filters are at the 64.455 MHz 1st IF output of the 1st mixer. They are
optimized for minimum passive IMD, to ensure best strong-signal handling.

16 October 2008 NSARC HF Operators – IC-7700 20

3 kHz Roofing Filter Passband

-•-• --•- - •• • ••• - • - - • •• - • ••• • -•

3 kHz roofing filter detail

3 kHz roofing filter passband (50 kHz span)

16 October 2008 NSARC HF Operators – IC-7700 21

Links for further study

-•-• --•- - •• • ••• - • - - • •• - • ••• • -•

! http://www.icom.co.jp/world/products/amateur/hf/ic-7700/

! http://www.icomamerica.com/en/products/amateur/hf/7700/default.aspx

! http://www.ab4oj.com/icom/ic7700/main.html

16 October 2008 NSARC HF Operators – IC-7700 22