Adhesive Joints: PPT To PDF Epoxy Adhesive Bonding Adhesive
Adhesive Joints: PPT To PDF Epoxy Adhesive Bonding Adhesive
► PPT to PDF
► Epoxy Adhesive
► Bonding Adhesive
to Polymers
to Adhesives
Adhesive joints
Dr. Dmitri Kopeliovich
Strength of an adhesive bonding strongly depends on the direction and distribution of the stresses formed
in the joint as a result of the loads applied to it.
Typical forces, which may be applied to adhesive joints are presented in the figure below.
www.substech.com/dokuwiki/doku.php?id=adhesive_joints 1/5
17/09/13 Adhesive joints [SubsTech]
Two aderends (substrate) may be bonded by different ways shown in the picture.
Lap and strap joints provide the maximal bonding strength. Butt joint is the weakest joint type.
www.substech.com/dokuwiki/doku.php?id=adhesive_joints 2/5
17/09/13 Adhesive joints [SubsTech]
www.substech.com/dokuwiki/doku.php?id=adhesive_joints 3/5
17/09/13 Adhesive joints [SubsTech]
The figure below presents design of several joint types at different loading conditions.
to top
to Polymers
to Adhesives
Except where otherwise noted, this work is licensed under a Creative Commons Attribution-
Noncommercial-Share Alike 3.0 License
www.substech.com/dokuwiki/doku.php?id=adhesive_joints 5/5