Scribd
Upload
95 views

MPT Report

The document summarizes a magnetic particle inspection test according to specification 0162 0030 US 8039-71. It details the magnetizing device model, magnetization method, field strength, clamping/contact points, technique, direction, magnetic particle type and method, surface condition, observation results, cleaning and marking requirements. The inspection found no slag due to material defects and no further cleaning or marking was required.

Uploaded by

Kamal Bhandari
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
95 views

MPT Report

The document summarizes a magnetic particle inspection test according to specification 0162 0030 US 8039-71. It details the magnetizing device model, magnetization method, field strength, clamping/contact points, technique, direction, magnetic particle type and method, surface condition, observation results, cleaning and marking requirements. The inspection found no slag due to material defects and no further cleaning or marking was required.

Uploaded by

Kamal Bhandari
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

According to test specification 0162 0030 US 8039-71

Date:
Part no.
Part name

Customer
PO no.
Invoice no.
Qty
Lot no.

Information of magnetising device


Model UNIMAG UCH 106 Source AC/HWDC

Magnetization Method Yoke Magnetization Self flooding


Field strength (KA/m) 2.5 to 4.0 2.5 to 4.0

Clamping / contact point: At both end of guide bolt

Technique: √ Continuous Residual Yoke


Direction: Longitudinal Circumferential √ Both

Part specific mounting device none

Magnetic Particle: Ferroflux GYF 101 (6 micron) Magnetic powder color: Greenish

Type Method
Visible color √ Fluorescent √ Wet Dry

Surface condition
As welded √ As Machined As casted As forged As other

Observation
No slag is observed due to material cracks , pores , wrinkle and voids.

Cleaning required Yes √ No

Marking stamp is
Yes √ No
required

Checked by Approved by

You might also like