Scribd
Upload
85 views

S80-Rfid en

The S80-RFID is a QR code and RFID reader that can be used for access control management. It has a fast reading speed of less than 200ms, supports various interface types, and can read QR codes from 3-6cm away or 0-20cm for RFID cards. It is powered by 4-15V and has LED status lights to indicate reading status. It can connect to access control panels or systems using Wiegand, RS-232, USB, or TCP/IP protocols.

Uploaded by

Richard Garcia Zarate
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
85 views

S80-Rfid en

The S80-RFID is a QR code and RFID reader that can be used for access control management. It has a fast reading speed of less than 200ms, supports various interface types, and can read QR codes from 3-6cm away or 0-20cm for RFID cards. It is powered by 4-15V and has LED status lights to indicate reading status. It can connect to access control panels or systems using Wiegand, RS-232, USB, or TCP/IP protocols.

Uploaded by

Richard Garcia Zarate
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

QR Code & RFID Reader S80-RFID

QR Code Access card Reader is our new intelligent Access Card Reader, Fast reading
speed, High recognition rate, Strong compatibility, can connect to any Wiegand input
contronller, widely Community visitor access management, Administration Service Hall
management, Gates access control, Visitors intelligent machines, Smart home; Upgrade
old access control systems etc.

Parameters
Item Parameters Item Parameters
QR Code, one dinensional
Card type EM or Mifare Decoding
code
Wiegand26/34, Decode
Interface Inmage decoding
RS232,USB,RS485,TCP/IP mode
Reading Reading
Camera centric slant 45° Auto-induction & beeper
directions feature
Voltages 4-15V Wide voltage input Current 800mA
Reading range
of range
3-6CM
Reading
speed
＜200ms
Reading range
0-20CM Materialcase PC & temperrd glass
of QR
Humidity 10%~90% Temperature ℃ ℃
-20 ~70
Operate
Windows(XP,7,8,10), Linux Size 86mm×86mm×42mm
system
Red-work,Green-feedback,Li
Status light Wight 150G
ght Green-internet
Use sharp objects inserted into RESET hole of QR code reader backside,
Remark
release till the QR code reader automatically restarted.

Wire connection
1 Leadwire

VCC
+DC GND D0 D1 LED BEEP TX/R+ RX/R- SPK- SPK+
12V

2 RJ45( ): connetc to network, PC software setting reader parameter(apply to


http mode);

3 Micro-USB( ): For USB virtual keyboard and USB virtual serial port mode
QR Code & RFID Reader S80-RFID

communication.
Remark:
Don’t connect the power to the SPK+ and SPK- ports;
Wiegand output: QR code shall comply with the principle of combination
HEX(hexadecimal) number 0~9&A~F. The QR code inaccordance with this principle
can heared a beep, controller can receive the card data; QR code not in accordance
with the principle can heard two beep, the controller can not receive the card data;
Wiegand output:Default Scans QR code output is DEC(Decimal).

Pictures

You might also like