Scribd
Upload
290 views

Glass Parapet With RC Kerb Fixing

This document provides design details for a glass parapet with a reinforced concrete kerb fixing. It specifies the glass thickness as 12mm and width as 1000mm with a height of 1.1m. The concrete kerb thickness is designed to be 50.32mm with #6 rebar spaced at 78mm. The railing design is also summarized, finding the span is not adequate to support the loads with only one end fixed when the infill panel breaks.

Uploaded by

jude
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
290 views

Glass Parapet With RC Kerb Fixing

This document provides design details for a glass parapet with a reinforced concrete kerb fixing. It specifies the glass thickness as 12mm and width as 1000mm with a height of 1.1m. The concrete kerb thickness is designed to be 50.32mm with #6 rebar spaced at 78mm. The railing design is also summarized, finding the span is not adequate to support the loads with only one end fixed when the infill panel breaks.

Uploaded by

jude
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Sheet1

GLASS PARAPET WITH RC KERB FIXING


P Udl (KN/M)= 0.74
Pt load= 0.5 Kn
Infill load= 1 KN/M2

Glass thk (mm)=


12

Glass width (mm)=


1000 H (M)= 1.1

Grout depth (mm)=


80

Setting block thk=


20 mm

Base moment= 0.81 Kn.m

Glass design
Bending stress on glass= 33.92 N/mm2
Glass type = T
temper=T , float glass =A, lamenated tempered glass=L
Allowable bending stress= 70 N/mm2
ok
Glass ht= 0.9 M
Deflection check on glass= 30 mm

Page 1
Sheet1

Conc. Kerb design


Reaction on kerb= (service) 13.57 Kn
Momwnt on kerb=(service) 1.09 Kn.m
Thk of kerb= 50 mm
Conc. service Stress on plain conc.= 4.17 N/mm2
Allowable service tensile stress of conc.= 1.41 N/mm2
need rebar
Rebar req.= 360.43 mm2
Use mild steel R , dia= 6
Spacing= 78.41 mm c.c

SHEAR
Min thk of conc= 50.32 mm

Summmary
Thk of kerb= 50.32 mm
Rebar = R 6 At spacing= 78

Railing design
Span with supportting elements on both end when the infill is broken
Span= 1M
moment(service)=wl2/11= 0.07 Kn.m
Railing capacity= 0.04
not ok
Span with supportting elements on one end only when the infill is broken
Span= 1M
Moment(service)=wl2/2= 0.37
Railing capacity= 0.1
not ok, to provide end restraint on free end

Page 2

You might also like