deVention Nos Wee come to use the DEVO-8S transmitter DEVO-8S also needs to make relative cancellation and. revision after the fixed ID in receiver Is cleared out. In the main interface touch the icon Il to enter Model Menu and then touch iio enter Fixed ID. Touch ID Code Selting to expand the navigation mark into status On and Off. Touch Off. Then touchkifto exit. 11.0 Installation requirement for receiver itis important to correctly mount your remote control system in your model, Below are some advices on how to install your equipments. (1) Wrap the receiver with 10mm thick foam and soundly fx t with a rubber or magic string on your aircraft model, It helps protect the receiver from damage. (2) Itis necessary to use rubber grommets and copper sleeves to isolate the vibrations from the main body. of aircraft model. The mounting screws cannot be over-lightened. Otherwise the rubber grommets will be distorted and decrease the vibration absorption effec. (3) When mounting the servos, make sure the servos’ bellcranks can move freely over their whole travel range ‘and ensure the control inkages don't touch or impede the movement of these servos. (4) If installing various switches, keep them far away from the engine tuned pipe and high vibration sources. Ensure all the switches move freely over their whole travel range. (5) Don't make the receiver antennas wrapped or parallel. antenna— fens arange Antenna aranges ly. Incorrect airectons| inwrong directions Installation requirement for DEVO-8S battery pack Open the battery cover of DEVO-8S transmitter and take out the batlery box. Then put 4 cells AA battery or the same size full charged NIMH battery into the battery box. Please check again to make sure the polarities are correct. Warning: Do not put the polarities of batteries in the opposite directions. [Cathode of te battery 12.1 DEVO-8S battery charging Warning: the CHG socket is only used for the rechargeable NIMH batteries. If using the batteries which is unchargeable. The CHG socket is not allowed to use. Charge socket(CHG):input DC at 8-12V,200mA; Polarity:@—3—-9 [CHG Charging Socket] DEVvo-8s ~ 12naan ion DEVO-8S ee eee ae ence} Pa rt two ree oe td Vench se ae fully integrated in System Menu, They include ETN Coxe) 0} (21 ail Mesiaareaionay oraereeniaraanior p Calibration, Stick Mode, Stick Calibration , and osdeVention ‘DEVO-85 aOR Cum Cale) All the functional settings, which are relative to the operation system of DEVO-8S itself, are fully integrated in System Menu. They include Language, Display, Buzzer, Touch Screen Calibration, Stick Mode, Stick Calibration , and About. Below is the boot screen of helicopter: Welcome to use the DEVO-8S transmitter Throttle tim Right trim ‘Transmission power display tr volume depiey Flight mode: Model name Rudder vim Throttle Dual ate and Model Alleron tein curve icon exponential ‘menu icon 1.4 Language Setting Touch the shortcut icon to enter System Menu and then touch [Blto enter the language interface. Touch the language that you want to select. A" v will be shown on the screen after selected. Then touchiiqjto save and exit. 1.1 Language Setting 1.2 Display 1.2 Display Touch the shortcut icon ito enter System Menu and then touch the iconfil to enter “Display” ‘Three items are available to be set. Below are the setting methods for them: (1) Backlight lightness: the backlight lightness is adjustable by touching the navigation marks. The power consumption will be increased if the backlight lightness is too bright and the battery cruise duration will be shortened, DEVvo-8s— 14