Scribd
Upload
78 views

Install Fly Wheel

This document provides installation instructions for a flywheel in 3 steps: 1. Clean the flywheel housing and inspect the crankshaft seal for leaks. Install guide bolts and a lifting device to position the flywheel. 2. Heat the ring gear to 480°F and quickly install it on the flywheel, ensuring correct orientation. Clean the assembled flywheel and ring gear. 3. Install the flywheel using setscrews, tightening them to 77 lb-ft. Check the flywheel alignment with the crankshaft.

Uploaded by

bagoes
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
78 views

Install Fly Wheel

This document provides installation instructions for a flywheel in 3 steps: 1. Clean the flywheel housing and inspect the crankshaft seal for leaks. Install guide bolts and a lifting device to position the flywheel. 2. Heat the ring gear to 480°F and quickly install it on the flywheel, ensuring correct orientation. Clean the assembled flywheel and ring gear. 3. Install the flywheel using setscrews, tightening them to 77 lb-ft. Check the flywheel alignment with the crankshaft.

Uploaded by

bagoes
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Flywheel - Install

SMCS - 1156-012

Installation Procedure

Table 1

Required Tools

Tool Part Number Part Description Qty

Guide Bolt
A - 2
(1/2 inch - 20 NF by 4 inch)

B 138-7575 Link Bracket 1

1. Thoroughly clean the flywheel housing. Inspect the crankshaft rear seal for leaks. If
there are any oil leaks refer to this Disassembly and Assembly Manual, "Crankshaft Rear
Seal - Remove".

3. Note: If the ring gear (3) has been removed from the flywheel (2), identify the orientation
of the ring gear (3) on the flywheel (2) for the correct positioning when the new ring gear
is installed.
4. Heat the ring gear (3) to 250 °C (480 °F) in an oven in order to install the ring gear onto
the flywheel (2). Ensure that the orientation of the ring gear (3) is correct and quickly
install the ring gear onto the flywheel (2).

Note: Do not use a torch to heat the ring gear.

5. Clean the flywheel (2) and the ring gear (3) when the ring gear has cooled.
6. Install the Tooling (A) on the crankshaft. Install the Tooling (B) and a suitable lifting
device on flywheel (2) and position the flywheel in the flywheel housing. The weight of
the flywheel is approximately 54 kg (119 lb).
7. Install the setscrews (1). Remove the Tooling (B).
8. Remove the Tooling (A). Install the remaining setscrews (1) that secure the flywheel (2)
to the crankshaft. Tighten the setscrews (1) to a torque of 105 N·m (77 lb ft).
9. Check the alignment of the flywheel (2) with the crankshaft. Refer to Testing and
Adjusting, "Flywheel - Inspect".

You might also like