Scribd
Upload
125 views

BS 2303 - The Pressure Limiter Valve Has A Break BS 0163 - Short or Interrupted CAN Wiring

The document discusses various error codes and potential issues for an Actros MP II truck from 2003. It describes two specific error codes that appeared: BS E 01 a 1 73 95 and GS E 01 a 2 80 99. For the first code, it suggests the issue could be related to the axis modulator, auxiliary pressure adjustment, damaged or insufficient system pressure, or a faulty sensor or modulator. For the second code, it indicates the problem concerns the coupling position sensor resistance and recommends checking the installation and potentially removing the actuator to inspect.

Uploaded by

Oumarba Kamanda
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
125 views

BS 2303 - The Pressure Limiter Valve Has A Break BS 0163 - Short or Interrupted CAN Wiring

The document discusses various error codes and potential issues for an Actros MP II truck from 2003. It describes two specific error codes that appeared: BS E 01 a 1 73 95 and GS E 01 a 2 80 99. For the first code, it suggests the issue could be related to the axis modulator, auxiliary pressure adjustment, damaged or insufficient system pressure, or a faulty sensor or modulator. For the second code, it indicates the problem concerns the coupling position sensor resistance and recommends checking the installation and potentially removing the actuator to inspect.

Uploaded by

Oumarba Kamanda
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

 GS 0163 - Communication fault with the control module of the parameterised PSM special

module

BS 2303 - The pressure limiter valve has a break


BS 0163 - Short or interrupted CAN wiring
 user has deleted the ...
The user has deleted the account
Helpful post? ( 0 )
# 183 21 Jun 2010 22:40
None of these defects causes "strange" burning and whipping in the exhaust.
Maybe the valves have been burned out or some pusher "went down".
Remove the valve covers, check the levers and clearances, as everything will keep going, take
off the exhaust connectors from the collectors to the turbine.
On this side where something does not run as you should you will have a wet collector. Then you
take off the entire collector and you know which head.
Unless you have access to a computer, then the measurements will show.

Damaged injector can also give "strange" symptoms, we do not hear it.
 LPG
Level 9
Helpful post? ( 0 )
# 184 27 Jun 2010 18:08
Hello.
I am looking for information on error codes for Actros MP II, 2003, today the following errors
have appeared and I do not know what causes them:
BS E 01 a 1 73 95
GS E 01 a 2 80 99.
VIN Number WDB 8340321K822454
 user has deleted the ...
The user has deleted the account
Helpful post? ( 0 )
# 185 27 Jun 2010 20:37
Axis modulator; adjustment of the auxiliary pressure.
Damage and insufficient system pressure may be damaged,
defective sensor built into the modulator or the entire modulator.
Check from the easiest.
The second error concerns the coupling, improper position sensor resistance.
Check the installation, to be sure you can also remove the actuator and check that it is no longer
too far behind the fork pusher.
A clutch of 400,000 can withstand normal operation, after this process it is worth controlling w

You might also like