Volvo Trucks North America

Greensboro, NC USA

D Service Bulletin
Date

5.2008
Trucks
Group

258

NOX Sensor and Control Module

No.

52

(Vertical DPF), Replacement

D11F, D13F, D16F
Page

1(5)

NOX Sensor and Control Module (Vertical DPF),

Replacement

W2006481

This information covers replacement of the NOX sensor and control module used for the
vertical DPF system with Volvo D11F, D13F and D16F engines.

Contents
• “NOX Sensor and Control Module, Replacement” page 2

Note: Information is subject to change without notice.

Illustrations are used for reference only and can differ slightly from the actual engine
version. However, key components addressed in this information are represented as
accurately as possible.

PV776-20150648 USA30114.ihval
Volvo Trucks North America
Service Bulletin

Service Procedures
2589-03-02-11 D
NOX Sensor and Control Module, Replacement
Date
5.2008
Group
258
No.
52

You must read and understand the precautions and

Page
2(5)

guidelines in Service Information, group 20, "General

Safety Practices, Engine" before performing this
procedure. If you are not properly trained and certified
in this procedure, ask your supervisor for training
before you perform it.

Removal
1
Apply the parking brake and place the shift lever
in neutral.

2
Remove all cables from ground (negative) battery
terminals to prevent personal injury from electrical shock.

W3007761

3
Cut all tie straps securing harness connector or sensor
lead.

W2006487
Volvo Trucks North America
Service Bulletin

D
4
Date
5.2008
Group
258
No.
52

Disconnect harness from NOx control module.

Page
3(5)

W2006488

5
Remove control module fasteners.

W2006489

6
Remove sensor from outlet module.

W2006490
Volvo Trucks North America
Service Bulletin

D
Installation
1
Date
5.2008
Group
258
No.
52

Apply a high temperature anti-seize compound to the

Page
4(5)

threads of replacement sensor. Install sensor into outlet

module. Tighten the sensor to specification.

Note: For torque specification, refer to the specification

bulletin in group 20.

W2006491

2
Install control module fasteners. Tighten fasteners
to specification.

W2006489

3
Connect harness to control module.

W2006488
Volvo Trucks North America
Service Bulletin

D
4
Date
5.2008
Group
258
No.
52

Secure harness and sensor lead with tie straps.

Page
5(5)

W2006487

5
Install all previously removed cables to the ground
(negative) battery terminals.

W3007761