Scribd
Upload
17 views1 page

Acceptable Methods and Standards

The document outlines the steps for preparing and testing a printed circuit board (PCB) as well as mounting and soldering electronic components. It specifies that the PCB layout must be verified against the schematic diagram and transferred to the board using standard methods. Visual inspections and drilling of holes is done according to procedures before testing the PCB functionality. Electronic components are mounted and soldered applying knowledge of soldering characteristics and following occupational health and safety standards, with the finished product checked against international standards.

Uploaded by

tog agga
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
17 views1 page

Acceptable Methods and Standards

The document outlines the steps for preparing and testing a printed circuit board (PCB) as well as mounting and soldering electronic components. It specifies that the PCB layout must be verified against the schematic diagram and transferred to the board using standard methods. Visual inspections and drilling of holes is done according to procedures before testing the PCB functionality. Electronic components are mounted and soldered applying knowledge of soldering characteristics and following occupational health and safety standards, with the finished product checked against international standards.

Uploaded by

tog agga
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Prepare/

Make PCB
Modules

2.1 PCB layout is verified for conformity with the schematic diagram in
accordance with the layout rules
2.2 PCB layout is transferred to copper-cladded board following
acceptable methods and standards
2.3 Visual inspection is performed based on standards procedures.
2.4 Thru-hole is drilled based on standards procedures
2.5 PCB is cleaned based on standards procedures
2.6 Functionality of PCB is tested and visual inspection is performed
based on standards procedures

Mount and
solder
electronic
components

3.1 Knowledge of lead and lead-free soldering characteristics and


requirements are applied to mounting and soldering process in
accordance with OH&S standards
3.2 Components are mounted and soldered in accordance with
soldering principles.
3.3 Soldering/Desoldering techniques and procedures are applied in
accordance with established standards and requirements.
3.4 Soldered products are checked and complied with international
standards and task specifications

You might also like