Installation guide

Shut-off ball valve for R744 (45 bar/650 psi)

Type GBC 6s to GBC 54s

009R9517
009R9517

Refrigerant: R744 (CO2) Max. working pressure (PS/MWP):

45 bar/650 psi
Temperature range: -40 – 150 °C / -40 – 300 °F

Applicable to all common non-flammable refrigerants, excluding R717. Also for noncorrosive

gases/liquids dependent on sealing material compatibility.
The design pressure shall not be less than the value outlined in Section 9.2 of ANSI/ASHRAE 15
for the refrigerant used in the system.
Warning: Only authorized persons are allowed to operate this valve, as closing
can cause build-up of excessive pressure in the system.
For the application use with R744 as part of a secondary loop or cascade system should
refer to the datasheet for more attentions.

Component
to be insulated
Danfoss
9G219.10

1 Remove access cap (if present)

Danfoss
9G230.11

Single-flow

2 Opening valve Max. Torque

9G229.10

Valve size
Danfoss

t Att
Nm ft-lbs
nu

6s - 22s 7 5.2
en
ove this

tion! D

o n em

28s 17 12.6
ut r

35s 20 14.8
42s - 54s 34 25.2

OPEN position nu
t Att CLOSED position nu
t Att
en
en

ove this
ove this

tion! D
tion! D

o n em o n em
ot r ot r

nut Att nut Att

en
ove this
en
ove this

tion! D
tion! D

o n re
m

o n re ot
ot

Danfoss Danfoss
9G227.10 9G228.10

© Danfoss | DCS (sw) | 2017.03 DKRCC.PI.FB0.C5.02 | 1

 3 Brazing

Danfoss
9G226.10

Min. 5% Ag
Max. 150°C
(300°F)

4 Install Schrader valve

and cap (if present)
Install Schrader valve
with approx. torque
Danfoss 0.3 Nm / 0.2 ft-lbs
9G224.11
9G209.10
Danfoss

Fully closed Fully open

A
nut tt A
nut tt A
nut tt
A
nut tt
en

en
ove this

en
en
ove this

ove this
ove this
tion! D

tion! D

tion! D
tion! D
m

o n re
m

m
m

ot o n re o n re o n re
ot ot ot

© Danfoss | DCS (sw) | 2017.03 DKRCC.PI.FB0.C5.02 | 2