Scribd
Upload
172 views

Water Recycling Car Wash System Using PLC: Components

This document describes a water recycling car wash system that uses a PLC to automate the car washing process through a 4-stage conveyor belt system. An IR sensor detects when a car is placed on the belt and initiates the washing process, moving the car through preliminary spraying, brush cleaning, dual spraying from top and bottom, and finally drying with fans. The system collects and filters water for reuse, saving water compared to traditional car washes.

Uploaded by

apoorva daga
Copyright
© © All Rights Reserved
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
172 views

Water Recycling Car Wash System Using PLC: Components

This document describes a water recycling car wash system that uses a PLC to automate the car washing process through a 4-stage conveyor belt system. An IR sensor detects when a car is placed on the belt and initiates the washing process, moving the car through preliminary spraying, brush cleaning, dual spraying from top and bottom, and finally drying with fans. The system collects and filters water for reuse, saving water compared to traditional car washes.

Uploaded by

apoorva daga
Copyright
© © All Rights Reserved
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 2

Water Recycling Car Wash System Using PLC

Car wash systems allow for fully automated car wash in a short amount of time. Here we
demonstrate a smart PLC based car wash system that allows for completely automated car
washing process. The system consists of a 4 stage car wash system. The system consists of a
small conveyor type belt that holds on to a car. The system has a IR sensor to check if a car has
been parked in the system. On detection the system now starts the belt movement using a
motorized system and vehicle moves to the first stage. This stage has a preliminary sprayer that
sprays water on the car and passes it to the next stage. The next one is a spinning brush system
that spins dual brushes to further clean and wipe the vehicle. The next stage is s dual sprayer that
sprays water from top as well as bottom to wash the car from both sides. The belt now takes the
car to the last step there we have DC fans to dry up the vehicle after the wash. The system allows
for an automated car washing process using PLC to detect vehicle and control its movement at
each step. The water poured on vehicle is collected under the mesh of the system and is passed
through a filter to reuse for the next wash, thus saving a lot of water unnecessarily wasted in car
washes.
Components

 Delta PLC
 Conveyor
 Pumps
 Pipes
 DC Motors
 Dryer Fans
 Floor Mesh
 Brushes
 Water Collector & Filter
 Brackets
 Mounts
 Joints
 Supporting Frame

Software Specifications

 Ladder Logic

You might also like