Wound Ballistics: Wounding Mechanism
Wound Ballistics: Wounding Mechanism
WOUNDING MECHANISM-
When a projectile strikes the human body, it depresses and compresses the skin,
flesh and bone underneath. The continued pressure stretches them beyond the
elastic limits and a hole is created. The stretched skin regains its normal state
after the hole is created and the bullet has entered inside. The diameter of the
hole on the skin, therefore appears, on the non-stretched skin somewhat smaller
than the size of the projectile which created the wound, when it was stretched.
The minimum velocity required to penetrate the human skin has been found to
be 40 to 50 metres per second. The threshold velocity for the penetration of a
bone is 60 meter per second.
The projectile continues its onwards progress till it leaves the body through an
exit hole, or, till its energy is spent beforehand, in overcoming the resistance.
The projectile is found lodged at the end of the tunnel, in later cases.
1. Nature of target.
2. Velocity of projectiles.
1
3. Constructional features of projectiles.
4. Range.
FIREARM INJURIES-
The projectiles fired by firearm have certain shapes, velocities and kinetic
energies which differ from most of the other agents causing injuries. The shapes
of wound, the destructive effect on the tissues, presence of foreign bodies (of
specific shapes and composition) and the projectile track help to identify
whether the given injury is a firearm injury or not.
5. fatal or not.
6. such that a person could perform the alleged acts after receiving the given
injuries.
7. of alleged age.
The evaluation of injuries can also indicate of the alleged number of shots fired
or the number of firearms used.
ENTRANCE WOUND-
1. The wounds are circular or oval in most of the cases. Key hole wounds
are also formed by wobbling bullets.
2. The diameter of the entrance hole is, ordinarily slightly less than the
diameter of the projectile creating the hole.
2
3. The edges are compressed inward – they are inverted.
4. A contusion ring is found around the wound in most of the times. The
ring is dark red to bluish-black depending upon its age.
5. The dirt or wipe ring is not always present but whenever it is present, it is
a sure sign of an entry wound.
6. Burning of skin, flesh or singeing of hair is caused when the shot is fired
from a close range. The scorched skin, when it is available, it identifies
the entry wound.
7. GSR deposits are from close range firing only. They also identify the
entrance wound whenever they are available.
9. Sometimes the bullet carries the GSR in their flight from the ejecta, from
the barrel fouling and deposit on the edges or inside the entrance hole.
Extraneous deposits around the wound are from the following sources-
2. Primer residue.
3. Projectile, Cartridge Case and barrel material (from fouling and bore
scraping).
4. Intermediate targets.
1. The weapon.
2. The ammunition.
3. The range.
3
PINK COLORATION-
If a shot is fired from a very close range or in contact with the skin, some
carbon monoxide (produced in the combustion of propellants) gets absorbed in
the skin and flesh. It gives a pink coloration to the skin around the wound which
indicates firearm injury and injury from a close range.
These are the effects of flame or hot gases produced in the combustion of
propellants. The charring is caused when the shot is fired from a very close
range. The size, shape and extent are characteristic of the firearm and range.
The Charring is often confused with the Blackening, Tattooing, Dirt Ring or
even with Contusion Ring. The Charring is different from Blackening. The later
can be removed with a cotton swab moistened with spirit while the former
cannot be removed in this way.
BLACKENING-
The blackening is caused by the smoke deposits. The smoke particles are light.
They do not travel afar. Therefore, smoke deposit i.e. blackening is limited to a
short range. The colour of smoke is grey to black in black powder and light grey
to dark grey in smokeless powder.
TATTOOING-
The dirt ring is deposited by some projectile around the wound. The materials
come from-
1. The projectile may carry grease on them. The dirt gets collected on the
grease which, in turn, gets deposited around the wound.
4
3. Dirt due to intermediate target (clothes, mud walls etc.) or from the
surface from which the projectile has ricocheted.
4. In shot gun ammunition, the pellets and buck shots are rubbed with
graphite. A small amount of graphite is carried by the projectiles which
they deposit around the entry hole. The lead bullets may also blacken the
edges of the entry wound.
FOREIGN MATERIAL-
The projectile or their fragments and sometimes the wads are found inside the
body, these may also indicate the nature of firearm used.
CONTUSION-
The edges of wound are contused by the impact of the projectile. The colour of
contusion varies from reddish dark to bluish black. The contusions are in the
form of a band around the wound and are often of uniform width. The tissues
are ruptured and swollen.
EXIT WOUND-
1. They have no fixed shape or size. Usually they are larger than entry
wound and are irregular.
2. The eversion of edges and the direction of pushed or pressed out flesh,
indicate the exit wound.
4. If the entry wound is established and a probe through this wound comes
out of another wound. The later is obviously an exit wound.
2. Describe fully the wound of entrance, the internal track and the
lodgement site or the exit wound. Give serial number to each injury. The
description should contain (whenever possible)
5
(a) The possible nature of firearm.
(a) Photographs – photograph the injury before and after cleaning, with a
scale and an identification information chit included in the
photographs. Photographs should fix the site of injury (ies) as well as
nature of injuries (close up). If there is extraneous material (GSR etc.),
it should be recorded photographically.
(e) In case of burning the charred skin piece may also be preserved.