Author Guidelines For Intizar Journal (Written Using TNR-12 Bold, 15 Words Maximum, Left Align)
Uploaded by
honey bee ENTERTAINMENTAuthor Guidelines For Intizar Journal (Written Using TNR-12 Bold, 15 Words Maximum, Left Align)
Uploaded by
honey bee ENTERTAINMENTAuthor Guidelines for Intizar Journal « (Written Using TNR-12 Bold,
15 Words Maximum, Left Align)
Nazarudin*) « (10pt, TNR Bold)
Universitas Islam Negeri Raden Fatah Palembang, Indonesia « (10pt, TNR)
Email: [email protected] « (10pt, TNR)
Padjrin
Universitas Islam Negeri Raden Fatah Palembang, Indonesia
Email: [email protected]
*) Corresponding Author
Abtract « (10pt, Times New Roman)
The abstract should be clear, concise, and descriptive. This abstract should provide a brief
introduction to the problem, objective of paper, followed by a statement regarding the
methodology and a brief summary of results. The abstract should end with a comment on
the significance of the results or a brief conclusion. Abstracts are written in 10 pt Times
New Roman, 100 to 150 words.
Keywords: « 10pt, Times New Roman: three-five word(s) or phrase(s), that are the labels
of your manuscript and critical to correct indexing and searching. Therefore the keywords
should represent the content and highlight of your article. Use only those abbreviations that
are firmly established in the field. e.g EFL, CLT, ESL, and others. Each words/phrase in
keyword should be separated by a comma (,).
Introduction « (11pt, Times New Roman)
In introduction, authors should state the objectives of the work at the end of
introduction section. Before the objective, authors should provide an adequate
background, and very short literature survey in order to record the existing
solutions/method, to show which is the best of previous researches, to show the
main limitation of the previous researches, to show what do you hope to achieve
(to solve the limitation), and to show the scientific merit or novelties of the paper.
Avoid a detailed literature survey or a summary of the results.
Method « (11pt, Times New Roman)
Method Section that describes the participants, the procedures employed in the
study such as technique of data collection and data analysis.
Result (s) and Discussion (s) « (11pt, Times New Roman)
This part consists of the research results and how they are discussed. The results
obtained from the research have to be supported by sufficient data. The research
results and the discovery must be the answers, or the research hypothesis stated
previously in the introduction part. The following components should be covered
in the discussion: How do your results relate to the original question or objectives
outlined in the Introduction section (what/how)? Do you provide interpretation
scientifically for each of your results or findings presented (why)? Are your results
consistent with what other investigators have reported (what else)? Or are there
any differences?
Conclusions and Recommendation « (11pt, Times New Roman)
Conclusion should answer the objectives of the research and the research
discoveries. The concluding remark should not contain only the repetition of the
results and discussions or abstract. You should also suggest future research and
point out those that are underway.
References
The bibliography should use reference management applications such
as Mendeley, EndNote, Zotero, or the other. The format of writing that used in the
journal of Engineering is in accordance with the format of APA 6 th Edition
(American Psychological Association).
FIGURE CAPTIONS
Figure 1: Sample of Figure
TABLE CAPTIONS
Table 1. Formatting Rules: 10pt, Times New Roman
Object Font Alignment Space above Space below
Title 10pt bold Centered 0pt 10pt
Author(s) 10pt bold Centered 10pt 10pt
Addresses 10pt italics Centered 0pt 0pt
Heading1 10pt bold Left 10pt 3pt
Heading2 10pt bold Left 6pt 3pt
Heading3 10pt bold Left 3pt 3pt
italics
Body 10pt Justified 0pt 0pt
Bullet 10pt Justified 0pt 0pt
Table title 10pt Centered 10pt 6pt
Figure title 10pt Centered 3pt 6pt
